Small-Scale System for Evaluation of Stretch-Flangeability with Excellent Reliability

Development of Methodology with Excellent Reproducibility for Evaluating Stretch-Flangeability Using a Sheared-Edge Tensile Test

(2017) J. I. Yoon et al.   EXPERIMENTAL MECHANICS

Key factors of stretch-flangeability of sheet materials

(2017) Jae Ik Yoon et al.   JOURNAL OF MATERIALS SCIENCE

Effect of Strength Coefficient of Bainite on Micromechanical Deformation and Failure Behaviors of Hot-Rolled 590FB Steel during Uniaxial Tension

(2016) Shi-Hoon Choi et al.   Korean Journal of Metals and Materials

Sensitivity of Microstructural Factors Influencing the Impact Toughness of Hypoeutectoid Steels with Ferrite-Pearlite Structure using Multiple Regression Analysis

(2016) Byoungchul Hwang et al.   Korean Journal of Metals and Materials

Correlation between fracture toughness and stretch-flangeability of advanced high strength steels

(2016) Jae Ik Yoon et al.   MATERIALS LETTERS

Factors governing hole expansion ratio of steel sheets with smooth sheared edge

(2016) Jae Ik Yoon et al.   METALS AND MATERIALS INTERNATIONAL

Size effect affected formability of sheet metals in micro/meso scale plastic deformation: Experiment and modeling

(2015) Z.T. Xu et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Influence of the initial grain size in single point incremental forming process for thin sheets metal and microparts: Experimental investigations

(2012) R. Ben Hmida et al.   MATERIALS & DESIGN

Development of hot rolled steel sheet with 600MPa UTS for automotive wheel application

(2012) Gajendra Jha et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Geometry and grain size effects on the fracture behavior of sheet metal in micro-scale plastic deformation

(2011) M.W. Fu et al.   MATERIALS & DESIGN

Application of extended Mohr–Coulomb criterion to ductile fracture

(2009) Yuanli Bai et al.   INTERNATIONAL JOURNAL OF FRACTURE

Improvement of stretch flangeability of ultra high strength steel sheet by smoothing of sheared edge

(2009) Ken-ichiro Mori et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY