An investigation of surface roughness and parametric optimization during wire electric discharge machining of cladded material

Optimization of Dry EDM Process Parameters Using Grey Relational Analysis

(2016) N. Pragadish et al.   ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING

Surface crack density and recast layer thickness analysis in WEDM process through response surface methodology

(2016) Anish Kumar et al.   MACHINING SCIENCE AND TECHNOLOGY

Experimental studies of the cutting force and surface morphology of explosively clad Ti–steel plates

(2016) P. Nieslony et al.   MEASUREMENT

Effect of wire diameter on surface integrity of wire electrical discharge machined Inconel 706 for gas turbine application

(2016) Priyaranjan Sharma et al.   Journal of Manufacturing Processes

Experimental investigation of kerf of Ti6Al4V exposed to different heat treatment processes in WEDM and optimization of parameters using genetic algorithm

(2015) Mehmet Altug et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Optimization of modern machining processes using advanced optimization techniques: a review

(2014) R. Venkata Rao et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Machining Characteristics of Inconel 718 by Sinking-EDM and Wire-EDM

(2014) L. Li et al.   MATERIALS AND MANUFACTURING PROCESSES

Multi-objective process optimization of wire electrical discharge machining based on response surface methodology

(2013) Danial Ghodsiyeh et al.   Journal of the Brazilian Society of Mechanical Sciences and Engineering

Effect of Wire-EDM Machining Parameters on Surface Roughness and Material Removal Rate of High Strength Armor Steel

(2013) Ravindranadh Bobbili et al.   MATERIALS AND MANUFACTURING PROCESSES

Effect of fatigue damage on static and dynamic tensile behaviour of electro-discharge machined Ti-6Al-4V

(2012) J. G. LÓPEZ et al.   FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES

Optimization of wire electrical discharge machining process parameters for cutting tungsten

(2011) Rong Tai Yang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Multi-objective parametric optimization on machining with wire electric discharge machining

(2011) Kapil Kumar et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

The use of grey relational analysis in solving multiple attribute decision-making problems

(2008) Yiyo Kuo et al.   COMPUTERS & INDUSTRIAL ENGINEERING