Experimental investigation of kerf of Ti6Al4V exposed to different heat treatment processes in WEDM and optimization of parameters using genetic algorithm

Parametric optimization for surface roughness, kerf and MRR in wire electrical discharge machining (WEDM) using Taguchi design of experiment

(2013) Adeel Ikram et al.   Journal of Mechanical Science and Technology

The evolution of microstructure of Ti–6Al–4V alloy during concurrent hot deformation and phase transformation

(2012) Lijia He et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Electrical discharge machining of Ti6Al4V with a bundled electrode

(2011) Lin Gu et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Effect of heat treatment on ballistic impact behavior of Ti–6Al–4V against 7.62mm deformable projectile

(2011) B. Bhav Singh et al.   MATERIALS & DESIGN

Investigation of mechanical behavior of quenched Ti–6Al–4V alloy by microindentation

(2011) Jun Cai et al.   MATERIALS CHARACTERIZATION

Evaluation of microstructural development in electron beam melted Ti-6Al-4V

(2011) A. Safdar et al.   MATERIALS CHARACTERIZATION

Optimization of drilling parameters on surface roughness in drilling of AISI 1045 using response surface methodology and genetic algorithm

(2010) Erol Kilickap et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

(2010) Aqueel Shah et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

In situ TiC particles reinforced Ti6Al4V matrix composite with a network reinforcement architecture

(2010) L.J. Huang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of porosity on mechanical properties and in vivo response of Ti6Al4V implants

(2009) Amit Bandyopadhyay et al.   Acta Biomaterialia

Correlation of adiabatic shearing behavior with fracture in Ti-6Al-4V alloys with different microstructures

(2008) Xinqin Liu et al.   INTERNATIONAL JOURNAL OF IMPACT ENGINEERING

Slicing, cleaning and kerf analysis of germanium wafers machined by wire electrical discharge machining

(2008) Dinesh Rakwal et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Machinability of titanium alloys (Ti6Al4V and Ti555.3)

(2008) P.-J. Arrazola et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY