Influence of model inclination on the melting behavior of graded metal foam composite phase change material: A pore-scale study

Thermal performance assessment of a thermal energy storage tank: effect of aspect ratio and tilted angle

(2021) Xiaohu Yang et al.   INTERNATIONAL JOURNAL OF ENERGY RESEARCH

Influence of fin parameters on the melting behavior in a horizontal shell-and-tube latent heat storage unit with longitudinal fins

(2021) Hongyang Li et al.   Journal of Energy Storage

Simulations of melting performance enhancement for a PCM embedded in metal periodic structures

(2021) Chunrong Zhao et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Phase change behaviour study of PCM tanks partially filled with graphite foam

(2021) Chunrong Zhao et al.   APPLIED THERMAL ENGINEERING

Different dimensional nanoadditives for thermal conductivity enhancement of phase change materials: Fundamentals and applications

(2021) Piao Cheng et al.   Nano Energy

Application of nanofluids for enhanced waste heat recovery: A review

(2021) A.G. Olabi et al.   Nano Energy

Effect of perforated fins on the heat-transfer performance of vertical shell-and-tube latent heat energy storage unit

(2021) Hongyang Li et al.   Journal of Energy Storage

Influence of cascaded graphite foams on thermal performance of high temperature phase change material storage systems

(2020) Michael Opolot et al.   APPLIED THERMAL ENGINEERING

Pore-scale simulation of forced convection heat transfer under turbulent conditions in open-cell metal foam

(2020) Mingrui Sun et al.   CHEMICAL ENGINEERING JOURNAL

Pore-scale investigation on the heat-storage characteristics of phase change material in graded copper foam

(2020) Chengzhi Hu et al.   APPLIED THERMAL ENGINEERING

Comparison of forced convective heat transfer between pillar and real foam structure under high Reynolds number

(2020) Mingrui Sun et al.   APPLIED THERMAL ENGINEERING

Numerical survey on performance of hybrid NePCM for cooling of electronics: Effect of heat source position and heat sink inclination

(2020) Hamza Faraji et al.   Journal of Thermal Science and Engineering Applications

Experimental study of the effect of inclination angle on the paraffin melting process in a square cavity

(2020) Abdel Illah Nabil Korti et al.   Journal of Energy Storage

Analysis of thermal performance of an improved shell and helically coiled heat exchanger

(2020) Azim Doğuş Tuncer et al.   APPLIED THERMAL ENGINEERING

Simulation of forced convective heat transfer in Kelvin cells with optimized skeletons

(2020) Mingrui Sun et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Pore-scale numerical simulation of the thermal performance for phase change material embedded in metal foam with cubic periodic cell structure

(2019) Xusheng Hu et al.   APPLIED THERMAL ENGINEERING

Fast waste heat recovery in 100–150 °C using close-contact charging of nano-enhanced PCM composite

(2019) Vikram Soni et al.   JOURNAL OF MOLECULAR LIQUIDS

Melting process investigation of phase change materials in a shell and tube heat exchanger enhanced with heat pipe

(2019) A. Ebrahimi et al.   RENEWABLE ENERGY

Review of stability and thermal conductivity enhancements for salt hydrates

(2019) Navin Kumar et al.   Journal of Energy Storage

Three-dimensional graphitic hierarchical porous carbon/stearic acid composite as shape-stabilized phase change material for thermal energy storage

(2019) Xialan Zhang et al.   APPLIED ENERGY

Perspectives for short-term thermal energy storage using salt hydrates for building heating

(2019) B.C. Zhao et al.   ENERGY

Performance improvements in solar flat plate collectors by integrating with phase change materials and fins: A CFD modeling

(2019) Z. Badiei et al.   ENERGY

Thermal performance of phase change material integrated heat pipe evacuated tube solar collector system: An experimental assessment

(2019) K. Chopra et al.   ENERGY CONVERSION AND MANAGEMENT

Dynamic of plumes and scaling during the melting of a Phase Change Material heated from below

(2018) Santiago Madruga et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Preparation of Lignosulfonate-Based Carbon Foams by Pyrolysis and Their Use in the Microencapsulation of a Phase Change Material

(2018) Martín A. Palazzolo et al.   ACS Sustainable Chemistry & Engineering

Investigation of the effect of inclination angle on the melting enhancement of phase change material in finned latent heat thermal storage units

(2018) Ramin Karami et al.   APPLIED THERMAL ENGINEERING

Experimental investigation of multiwall carbon nanotube/paraffin based heat sink for electronic device thermal management

(2018) Amin Farzanehnia et al.   ENERGY CONVERSION AND MANAGEMENT

Pore Scale Investigation of Heat Conduction of High Porosity Open-Cell Metal Foam/Paraffin Composite

(2017) Yuanpeng Yao et al.   JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME

Enhanced latent heat thermal energy storage in the double tubes using fins

(2016) Wei-Biao Ye   JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY

Numerical modeling of heat transfer in open-cell micro-foam with phase change material

(2015) Xin Hu et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Pore-scale and volume-averaged numerical simulations of melting phase change heat transfer in finned metal foam

(2015) Shangsheng Feng et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Thermal management of electronic devices using carbon foam and PCM/nano-composite

(2015) W.G. Alshaer et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Experimental analysis of phase change phenomenon of paraffin waxes embedded in copper foams

(2015) Simone Mancin et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Effective thermal conductivity of open-cell metal foams impregnated with pure paraffin for latent heat storage

(2014) X. Xiao et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

The effect of pore size and porosity on thermal management performance of phase change material infiltrated microcellular metal foams

(2013) Sriharsha S. Sundarram et al.   APPLIED THERMAL ENGINEERING

Experimental investigations on thermal performance enhancement and effect of orientation on porous matrix filled PCM based heat sink

(2013) Rajesh Baby et al.   INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER

A review of materials, heat transfer and phase change problem formulation for latent heat thermal energy storage systems (LHTESS)

(2009) Francis Agyenim et al.   RENEWABLE & SUSTAINABLE ENERGY REVIEWS

Simulation of Thermal Transport in Open-Cell Metal Foams: Effect of Periodic Unit-Cell Structure

(2008) Shankar Krishnan et al.   JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME