Preliminary Investigation of Building Strategies of Maraging Steel Bulk Material Using Wire + Arc Additive Manufacture

Oxide accumulation effects on wire + arc layer-by-layer additive manufacture process

(2018) Xiangfang Xu et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Microstructural evolution and mechanical properties of maraging steel produced by wire + arc additive manufacture process

(2017) Xiangfang Xu et al.   MATERIALS CHARACTERIZATION

A Comparative Study of Additively Manufactured Thin Wall and Block Structure with Al-6.3%Cu Alloy Using Cold Metal Transfer Process

(2017) Baoqiang Cong et al.   Applied Sciences-Basel

Microstructural evolution, nanoprecipitation behavior and mechanical properties of selective laser melted high-performance grade 300 maraging steel

(2017) Chaolin Tan et al.   MATERIALS & DESIGN

Investigation on direct laser powder deposition of 18 Ni (300) marage steel using mathematical model and experimental characterisation

(2016) Sabina Luisa Campanelli et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Precipitation Reactions in Age-Hardenable Alloys During Laser Additive Manufacturing

(2016) Eric A. Jägle et al.   JOM

The effect of inter-layer cold working and post-deposition heat treatment on porosity in additively manufactured aluminum alloys

(2016) Jianglong Gu et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Development of a laminar flow local shielding device for wire + arc additive manufacture

(2015) J. Ding et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Experimental investigation and statistical optimisation of the selective laser melting process of a maraging steel

(2015) G. Casalino et al.   OPTICS AND LASER TECHNOLOGY

Effect of arc mode in cold metal transfer process on porosity of additively manufactured Al-6.3%Cu alloy

(2014) Baoqiang Cong et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Metal Additive Manufacturing: A Review

(2014) William E. Frazier   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Microstructure and residual stress improvement in wire and arc additively manufactured parts through high-pressure rolling

(2013) Paul A. Colegrove et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Mechanical Properties of INCONEL 718 Parts Manufactured by Shaped Metal Deposition (SMD)

(2011) Bernd Baufeld   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

The arc characteristics and metal transfer behaviour of cold metal transfer and its use in joining aluminium to zinc-coated steel

(2008) H.T. Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING