Investigation on direct laser powder deposition of 18 Ni (300) marage steel using mathematical model and experimental characterisation

Effects of process time interval and heat treatment on the mechanical and microstructural properties of direct laser deposited 316L stainless steel

(2015) Aref Yadollahi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Experimental study of porosity reduction in high deposition-rate Laser Material Deposition

(2015) Chongliang Zhong et al.   OPTICS AND LASER TECHNOLOGY

Experimental investigation and statistical optimisation of the selective laser melting process of a maraging steel

(2015) G. Casalino et al.   OPTICS AND LASER TECHNOLOGY

Assessment of laser cladding as an option for repairing/enhancing rails

(2015) S.R. Lewis et al.   WEAR

Investigation of effect of process parameters on multilayer builds by direct metal deposition

(2014) Tarak Amine et al.   APPLIED THERMAL ENGINEERING

Remanufacturing of turbine blades by laser direct deposition with its energy and environmental impact analysis

(2014) J. Michael Wilson et al.   JOURNAL OF CLEANER PRODUCTION

Effect of density and pore morphology on fatigue properties of sintered Ti–6Al–4V

(2013) Yingjie Yan et al.   INTERNATIONAL JOURNAL OF FATIGUE

Optimization of Ni-Based WC/Co/Cr Composite Coatings Produced by Multilayer Laser Cladding

(2013) Andrea Angelastro et al.   Advances in Materials Science and Engineering

Laser surface melting: A suitable technique to repair damaged surfaces made in 14 Ni (200 grade) maraging steel

(2012) M. Cabeza et al.   SURFACE & COATINGS TECHNOLOGY

Numerical and experimental investigation of multilayer SS410 thin wall built by laser direct metal deposition

(2011) Yongjie Zhang et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Investigation into the direct laser forming process of steam turbine blade

(2011) Z.L. Lu et al.   OPTICS AND LASERS IN ENGINEERING

Analysis and prediction of single laser tracks geometrical characteristics in coaxial laser cladding process

(2011) Hussam El Cheikh et al.   OPTICS AND LASERS IN ENGINEERING

FEM modeling and experimental verification for dilution control in laser cladding

(2010) J.T. Hofman et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Microstructure evolution during laser-aided direct metal deposition of alloy tool steel

(2010) Guifang Sun et al.   SCRIPTA MATERIALIA

Pore Formation in Laser-Assisted Powder Deposition Process

(2009) L. Wang et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Effects of Deformation-Induced Constraint on High-Cycle Fatigue in Ti Alloys with a Duplex Microstructure

(2008) K.S. Chan et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE