Structure, adhesion and corrosion behavior of CrN/TiN superlattice coatings deposited by the combined deep oscillation magnetron sputtering and pulsed dc magnetron sputtering

Deep oscillation magnetron sputtering (DOMS) is a novel high power impulse magnetron sputtering technique, which offers large voltage oscillation packets to generate a stable high-power discharge plasma with high ionization under virtually arc-free conditions. CrN/TiN superlattice coatings with various modulated periods (A) were deposited by the combined DOMS and pulsed dc magnetron sputtering. CrN/TiN superlattice coatings with the Cr/(Cr + Ti) ratio ranging from 0.177 to 0.496 exhibited a single phase face-centered cubic structure with a strong (111) texture. As the A was increased from 5.7 to 10.2 nm, the residual stress was increased from 2.1 to -5.6 GPa. The increase in A led to an initial increase, followed by a decrease in hardness, and the H/E* and H-3/E*(2) ratios. The coating at A = 6.3 nm showed the highest adhesion with the highest HF level in Rockwell C tests and critical loads in scratch tests due to the highest hardness of 36 GPa, H/E* ratio of 0.093 and H-3/E*(2) ratio of 0.316. The predominant adhesive failure mode in scratch tests was budding failure independent of the changes of A and substrate hardness. However, the increase in substrate hardness resulted in an increase in critical loads (L-C1, L-C2, L-C3 and L-C4), especially for a significant increase in L-C3, due to the increased cooperative deformation of a coating/substrate system by increasing toughness of coatings, cohesion/adhesion and substrate hardness. The increased adhesion was responsible for the increased pitting and stress corrosion cracking resistance in 3.5 wt.% NaCl aqueous solution due to the optimized Cr/(Cr + Ti) ratio and A. (C) 2015 Elsevier B.V. All rights reserved.