Achieving strength and ductility synergy via a nanoscale superlattice precipitate in a cast Mg-Y-Zn-Er alloy

Enhanced strength-ductility synergy via novel bifunctional nano-precipitates in a high-entropy alloy

(2022) Liyuan Liu et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Alloying design and microstructural control strategies towards developing Mg alloys with enhanced ductility

(2022) Zhong-Zheng Jin et al.   Journal of Magnesium and Alloys

α-Mg/LPSO (Long-Period Stacking Ordered) phase interfaces as obstacles against dislocation slip in as-cast Mg-Zn-Y alloys

(2022) Tsuyoshi Mayama et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Strengthening CrFeCoNiMn0.75Cu0.25 high entropy alloy via laser shock peening

(2022) Wujing Fu et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Plastic anisotropy and twin distributions near the fatigue crack tip of textured Mg alloys from in situ synchrotron X-ray diffraction measurements and multiscale mechanics modeling

(2022) Di Xie et al.   JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS

Chemical fluctuation enabling strength-plasticity synergy in metastable single-phase high entropy alloy film with gigapascal yield strength

(2021) J.Y. Zhang et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Micromechanical origin of the enhanced ductility in twinless duplex Mg–Li alloy

(2021) Di Xie et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Understanding chemical short-range ordering/demixing coupled with lattice distortion in solid solution high entropy alloys

(2021) Q.F. He et al.   ACTA MATERIALIA

Balancing the strength and ductility of Mg-6Zn-0.2Ca alloy via sub-rapid solidification combined with hard-plate rolling

(2021) Zhong-Zheng Jin et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

The influence of shearable and nonshearable precipitates on the Portevin-Le Chatelier behavior in precipitation hardening AlMgScZr alloys

(2021) Han Chen et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Synergy of strengthening and toughening of a Cu-rich precipitate-strengthened steel

(2021) Xinghao Wei et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Generalized stacking fault energy surface mismatch and dislocation transformation

(2021) Longsheng Feng et al.   npj Computational Materials

Mechanical properties and deformation mechanisms of a novel austenite-martensite dual phase steel

(2020) S.S. Xu et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Cryogenic mechanical behaviors of CrMnFeCoNi high-entropy alloy

(2020) Wujing Fu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Relieving segregation in twin-roll cast Mg–8Al–2Sn–1Zn alloys via controlled rolling

(2020) Shao-You Zhang et al.   Journal of Magnesium and Alloys

Effect of heat treatment on LPSO morphology and mechanical properties of Mg–Zn–Y–Gd alloys

(2020) Hongxin Liao et al.   Journal of Magnesium and Alloys

Anti-phase boundary energy of β series precipitates in Mg-Y-Nd system

(2020) Yanlin Guo et al.   SCRIPTA MATERIALIA

Fracture of an anisotropic rare-earth-containing magnesium alloy (ZEK100) at different stress states and strain rates: Experiments and modeling

(2019) Saadi A. Habib et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Effect of Y and Gd content on the microstructure and mechanical properties of Mg–Y–RE alloys

(2019) Kang Luo et al.   Journal of Magnesium and Alloys

Characterization of elevated-temperature high strength and decent thermal conductivity extruded Mg-Er-Y-Zn alloy containing nano-spaced stacking faults

(2019) Yan Feng et al.   MATERIALS CHARACTERIZATION

A high-strength low-rare-earth-alloyed magnesium alloy via traditional hot-extrusion

(2019) Dongdong Zhang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effect of substitution of Zn with Ni on microstructure evolution and mechanical properties of LPSO dominant Mg–Y–Zn alloys

(2019) Jinbei Lyu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Elastic properties of long-period stacking ordered phases in Mg–Zn–Y and Mg–Ni–Y alloys: A first-principles study

(2019) Yanlin Guo et al.   SCRIPTA MATERIALIA

In-situ neutron diffraction of a quasicrystal-containing Mg alloy interpreted using a new polycrystal plasticity model of hardening due to {10.2} tensile twinning

(2018) S.R. Agnew et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Realizing strength-ductility combination of coarse-grained Al 0.2 Co 1.5 CrFeNi 1.5 Ti 0.3 alloy via nano-sized, coherent precipitates

(2018) Kaisheng Ming et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Effect of the morphology of long-period stacking ordered phase on mechanical properties and corrosion behavior of cast Mg-Zn-Y-Ti alloy

(2018) Peng Cheng et al.   JOURNAL OF ALLOYS AND COMPOUNDS

An Orowan precipitate strengthening equation for mechanical twinning in Mg

(2018) Matthew R. Barnett et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Nanoscale precipitation and its influence on strengthening mechanisms in an ultra-high strength low-carbon steel

(2018) S.S. Xu et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Anisotropy, tension-compression asymmetry and texture evolution of a rare-earth-containing magnesium alloy sheet, ZEK100, at different strain rates and temperatures: Experiments and modeling

(2017) Saadi A. Habib et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Effects of Ni levels on microstructure and mechanical properties of Mg-Ni-Y alloy reinforced with LPSO structure

(2017) Xiong Yang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

High strength Mg-Zn-Y alloys reinforced synergistically by Mg 12 ZnY phase and Mg 3 Zn 3 Y 2 particle

(2017) J. Zhu et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Excellent ductility and strong work hardening effect of as-cast Mg-Zn-Zr-Yb alloy at room temperature

(2017) Dongdong Zhang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Twin-induced hardening in extruded Mg alloy AM30

(2017) Hua Qiao et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ultrastrong steel via minimal lattice misfit and high-density nanoprecipitation

(2017) Suihe Jiang et al.   NATURE

High dislocation density–induced large ductility in deformed and partitioned steels

(2017) B. B. He et al.   SCIENCE

A Review on Casting Magnesium Alloys: Modification of Commercial Alloys and Development of New Alloys

(2016) Fusheng Pan et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

Mechanical properties and failure characteristics of cast and extruded Mg 97 Y 2 Zn 1 alloys with LPSO phase

(2016) Mitsuhiro Okayasu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of long-period stacking ordered phase on microstructure, mechanical property and corrosion resistance of Mg alloys: A review

(2016) Daokui Xu et al.   Progress in Natural Science-Materials International

Effect of long-period stacking ordered phase on microstructure, mechanical property and corrosion resistance of Mg alloys: A review

(2016) Daokui Xu et al.   Progress in Natural Science-Materials International

Back stress strengthening and strain hardening in gradient structure

(2016) Muxin Yang et al.   Materials Research Letters

Crystal structures of highly-ordered long-period stacking-ordered phases with 18 R , 14 H and 10 H -type stacking sequences in the Mg–Zn–Y system

(2015) Kyosuke Kishida et al.   ACTA MATERIALIA

On the room temperature deformation mechanisms of a Mg–Y–Zn alloy with long-period-stacking-ordered structures

(2015) Jin-Kyung Kim et al.   ACTA MATERIALIA

Effects of heat treatment on the morphology of long-period stacking ordered phase, the corresponding damping capacities and mechanical properties of Mg–Zn–Y alloys

(2015) Ruopeng Lu et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effects of Ca on the formation of LPSO phase and mechanical properties of Mg-Zn-Y-Mn alloy

(2015) Jie Wang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructural development of high temperature deformed AZ31 magnesium alloys

(2015) Peiman Shahbeigi Roodposhti et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Role of RE in the deformation and recrystallization of Mg alloy and a new alloy design concept for Mg–RE alloys

(2015) In-Ho Jung et al.   SCRIPTA MATERIALIA

Ductility improvement of Mg alloys by solid solution: Ab initio modeling, synthesis and mechanical properties

(2014) S. Sandlöbes et al.   ACTA MATERIALIA

Predicting β′ precipitate morphology and evolution in Mg–RE alloys using a combination of first-principles calculations and phase-field modeling

(2014) Y.Z. Ji et al.   ACTA MATERIALIA

Isotropic and kinematic hardening as functions of gamma prime precipitates in a nickel-based superalloy

(2014) Kimberly Maciejewski et al.   INTERNATIONAL JOURNAL OF FATIGUE

Tension–compression yield asymmetry in as-cast magnesium alloy

(2014) Sung Hyuk Park et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Physical factors controlling the observed high-strength precipitate morphology in Mg–rare earth alloys

(2013) A. Issa et al.   ACTA MATERIALIA

Microstructure and mechanical properties of high-performance Mg–Y–Er–Zn extruded alloy

(2013) Li Zhang et al.   MATERIALS & DESIGN

Effect of Rare-Earth Additions on the Texture of Wrought Magnesium Alloys: The Role of Grain Boundary Segregation

(2013) Joseph D. Robson   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

The formation of randomly textured magnesium alloy sheet through rapid solidification

(2010) N. Stanford et al.   ACTA MATERIALIA

Microstructure and super high strength of cast Mg-8.5Gd-2.3Y-1.8Ag-0.4Zr alloy

(2010) Qudong Wang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Partition of Er among the constituent phases and the yield phenomenon in a semi-continuously cast Mg–Zn–Zr alloy

(2010) Jing Zhang et al.   SCRIPTA MATERIALIA

Preface to the viewpoint set on: The current state of magnesium alloy science and technology

(2010) S.R. Agnew et al.   SCRIPTA MATERIALIA

Effects of rare-earth elements Gd and Y on the solid solution strengthening of Mg alloys

(2009) L. Gao et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effects of hot rolling processing on microstructures and mechanical properties of Mg–3%Al–1%Zn alloy sheet

(2009) L. Jin et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Strain hardening behaviour and the Taylor factor of pure magnesium

(2008) C.H. Cáceres et al.   PHILOSOPHICAL MAGAZINE

Effect of microalloying with rare-earth elements on the texture of extruded magnesium-based alloys

(2008) N. Stanford et al.   SCRIPTA MATERIALIA

Age hardening and mechanical properties of Mg–Gd–Er alloy

(2007) Qiuming Peng et al.   JOURNAL OF ALLOYS AND COMPOUNDS