Variation in taper surface roughness for a single design effects the wear rate in total hip arthroplasty

Quantification of the Contact Area at the Head-Stem Taper Interface of Modular Hip Prostheses

(2015) Florian Witt et al.   PLoS One

Influence of stem type on material loss at the metal-on-metal pinnacle taper junction

(2015) Harry S Hothi et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART H-JOURNAL OF ENGINEERING IN MEDICINE

The effect of frictional torque and bending moment on corrosion at the taper interface

(2015) A. Panagiotidou et al.   Bone & Joint Journal

Taperosis

(2015) C. Del Balso et al.   Bone & Joint Journal

Mechanically Assisted Taper Corrosion in Modular TKA

(2014) Christina M. Arnholt et al.   JOURNAL OF ARTHROPLASTY

The absence of a metal-on-metal bearing does not preclude the formation of a destructive pseudotumor in the hip—a case report

(2013) Pepijn Bisseling et al.   Acta Orthopaedica

Taper Design Affects Failure of Large-head Metal-on-metal Total Hip Replacements

(2013) Nader A. Nassif et al.   CLINICAL ORTHOPAEDICS AND RELATED RESEARCH

Enhanced wear and corrosion in modular tapers in total hip replacement is associated with the contact area and surface topography

(2013) Anna Panagiotidou et al.   JOURNAL OF ORTHOPAEDIC RESEARCH

Taper junction failure in large-diameter metal-on-metal bearings

(2013) D. J. Langton et al.   Bone & Joint Research

Volumetric wear assessment of retrieved metal-on-metal hip prostheses and the impact of measurement uncertainty

(2011) P.J. Bills et al.   WEAR