4.8 Article

Screening of microplastics in water and sludge lines of a drinking water treatment plant in Catalonia, Spain

Journal

WATER RESEARCH
Volume 225, Issue -, Pages -

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.watres.2022.119185

Keywords

Plastic pollution; Drinking water; Sludge; Removal ratios

Funding

  1. Juan de la Ciervaincorporacion program of the Spanish Ministerio de Ciencia, Innovacion y Universidades [IJC 2018-035126-I]
  2. predoctoral fellowship Marti i Franques [2019-PMF-PIPF-80]
  3. European Commission [EXP 00119498/SERA-20191002]
  4. CDTI [EXP 00119498/SERA-20191002]

Ask authors/readers for more resources

Microplastics (MPs) were detected in a drinking water treatment plant near Barcelona, with fibers being the most dominant morphology. Common polymer types identified were synthetic cellulose, polyester, and polyamide. Ingestion of MPs from drinking water was not as important as ingestion from fish and seafood.
Microplastics (MPs) are emerging pollutants detected everywhere in the environment, with the potential to harm living organisms. The present study investigated the concentration, morphology, and composition of MPs, between 20 mu m and 5 mm, in a drinking water treatment plant (DWTP) located close to Barcelona (Catalonia, NE Spain). The sampling included different units of the DWTP, from influent to effluent as well as sludge line. Sampling strategy, filtration, allows sampling of large volumes of water avoiding sample contamination, and during 8 h in order to increase the representativeness of MPs collected. The pre-treatment of the samples consisted of advanced oxidation with Fenton's reagent and hydrogen peroxide, followed by density separation of the particles with zinc chloride solution. Visual identification was performed with an optical and stereoscopic microscope with final Fourier-transform infrared spectroscopic (FTIR) confirmation. MPs were found in all DWTP samples, with concentrations from 4.23 +/- 1.26 MPs/L to 0.075 +/- 0.019 MPs/L in the influent and effluent of the plant, respectively. The overall removal efficiency of the plant was 98.3%. The most dominant morphology was fibers followed by fragments and films. Twenty-two different polymer types were identified and synthetic cellulose, polyester, polyamide, polypropylene, polyethylene, polyurethane, and polyacrylonitrile were the most common. Although MPs could be incorporated from the distribution network, MPs intake from drinking water from this DWTP was not an important route compared to fish and seafood ingestion.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available