Exceptional mechanical properties of aluminum matrix composites with heterogeneous structure induced by in-situ graphene nanosheet-Cu hybrids

Simultaneously enhanced strength and ductility of Al matrix composites through the introduction of intragranular nano-sized graphene nanoplates

(2021) Tielong Han et al.   COMPOSITES PART B-ENGINEERING

Achieving prominent strengthening efficiency of graphene nanosheets in Al matrix composites by hybrid deformation

(2021) Bowen Pu et al.   CARBON

Improving the high-cycle fatigue strength of heterogeneous carbon nanotube/Al-Cu-Mg composites through grain size design in ductile-zones

(2021) K. Ma et al.   COMPOSITES PART B-ENGINEERING

Hierarchical microstructure architecture: A roadmap towards strengthening and toughening reduced graphene oxide/2024Al matrix composites synthesized by flake powder thixoforming

(2020) Pubo Li et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Microstructures and mechanical properties of an Al-Cu-Mg-Sc alloy reinforced with in-situ TiB2 particulates

(2020) Siming Ma et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

The superior mechanical and physical properties of nanocarbon reinforced bulk composites achieved by architecture design – A review

(2020) Xiang Zhang et al.   PROGRESS IN MATERIALS SCIENCE

Trimodal grain structure enables high-strength CNT/Al-Cu-Mg composites higher ductility by powder assembly & alloying

(2020) Xiaowen Fu et al.   Materials Research Letters

Heterostructured materials: superior properties from hetero-zone interaction

(2020) Yuntian Zhu et al.   Materials Research Letters

Revealing the strengthening and toughening mechanisms of Al-CuO composite fabricated via in-situ solid-state reaction

(2020) Xudong Rong et al.   ACTA MATERIALIA

Perspective on hetero-deformation induced (HDI) hardening and back stress

(2019) Yuntian Zhu et al.   Materials Research Letters

Bioinspired, graphene-enabled Ni composites with high strength and toughness

(2019) Yunya Zhang et al.   Science Advances

High-temperature mechanical properties of 2024 Al matrix nanocomposite reinforced by TiC network architecture

(2019) Huabing Yang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High-strength graphene network reinforced copper matrix composites achieved by architecture design and grain structure regulation

(2019) Xiang Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effects of Microstructure on Mechanical Properties of Harmonic Structure Designed Pure Ni

(2019) Masaya Nagata et al.   MATERIALS TRANSACTIONS

A novel method for preparing graphene nanosheets/Al composites by accumulative extrusion-bonding process

(2019) Gaohui Wu et al.   CARBON

Manipulating the plastic strain delocalization through ultra-thinned hierarchical design for strength-ductility synergy

(2019) Hao Wu et al.   SCRIPTA MATERIALIA

Enhancement of the strength-ductility relationship for carbon nanotube/Al–Cu–Mg nanocomposites by material parameter optimisation

(2019) Z.Y. Liu et al.   CARBON

Extraordinary reinforcing effect of carbon nanotubes in aluminium matrix composites assisted by in-situ alumina nanoparticles

(2019) B. Chen et al.   COMPOSITES PART B-ENGINEERING

Microstructure and properties of copper coated graphene nanoplates reinforced Al matrix composites developed by low temperature ball milling

(2019) Tielong Han et al.   CARBON

Stress relaxation and the cellular structure-dependence of plastic deformation in additively manufactured AlSi10Mg alloys

(2019) Zan Li et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Microstructural evolution and deformation behavior of Al-Cu alloys: A Transmission X-ray Microscopy (TXM) and micropillar compression study

(2018) C. Shashank Kaira et al.   ACTA MATERIALIA

Interface structure and strengthening behavior of graphene/CuCr composites

(2018) Ke Chu et al.   CARBON

Tailoring the structure and mechanical properties of graphene nanosheet/aluminum composites by flake powder metallurgy via shift-speed ball milling

(2018) Yuanyuan Jiang et al.   COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING

Microstructure and tensile properties of 5083 Al matrix composites reinforced with graphene oxide and graphene nanoplates prepared by pressure infiltration method

(2018) Puzhen Shao et al.   COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING

Creation of individual few-layer graphene incorporated in an aluminum matrix

(2018) Weiwei Zhou et al.   COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING

Interface affected zone for optimal strength and ductility in heterogeneous laminate

(2018) C.X. Huang et al.   Materials Today

Graphene defect engineering for optimizing the interface and mechanical properties of graphene/copper composites

(2018) Ke Chu et al.   CARBON

High strength and ductility of graphene-like carbon nanosheet/copper composites fabricated directly from commercial oleic acid coated copper powders

(2018) Ziyue Yang et al.   Nanoscale

Effect of Interface Structure on the Mechanical Properties of Graphene Nanosheets Reinforced Copper Matrix Composites

(2018) Xiang Zhang et al.   ACS Applied Materials & Interfaces

Effect of ball milling time on graphene nanosheets reinforced Al6063 composite fabricated by pressure infiltration method

(2018) Zhenhe Yu et al.   CARBON

In situ synthesis of copper-modified graphene-reinforced aluminum nanocomposites with balanced strength and ductility

(2018) Jie Wang et al.   JOURNAL OF MATERIALS SCIENCE

Enhanced strength and ductility in ZrB2/2024Al nanocomposite with a quasi-network architecture

(2018) Z.Y. Zhang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Creating defects on graphene basal-plane toward interface optimization of graphene/CuCr composites

(2018) Ke Chu et al.   CARBON

Enhancement of strength-ductility trade-off in a high-entropy alloy through a heterogeneous structure

(2018) S.W. Wu et al.   ACTA MATERIALIA

The fabrication of graphene-reinforced Al-based nanocomposites using high-pressure torsion

(2018) Yi Huang et al.   ACTA MATERIALIA

Interfacial reaction induced efficient load transfer in few-layer graphene reinforced Al matrix composites for high-performance conductor

(2018) Weiwei Zhou et al.   COMPOSITES PART B-ENGINEERING

Effect of carbon nanotubes and high temperature extrusion on the microstructure evolution of Al-Cu alloy

(2017) Chunhong Li et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Lateral size effect of graphene on mechanical properties of aluminum matrix nanolaminated composites

(2017) Mei Zhao et al.   SCRIPTA MATERIALIA

Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloy

(2017) Y. H. Jo et al.   Nature Communications

Back stress in strain hardening of carbon nanotube/aluminum composites

(2017) Run Xu et al.   Materials Research Letters

Heterogeneous materials: a new class of materials with unprecedented mechanical properties

(2017) Xiaolei Wu et al.   Materials Research Letters

Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al–Zn–Mg alloys

(2016) Kaka Ma et al.   ACTA MATERIALIA

Mechanical properties of copper/bronze laminates: Role of interfaces

(2016) Xiaolong Ma et al.   ACTA MATERIALIA

Toughening of aluminum matrix nanocomposites via spatial arrays of boron carbide spherical nanoparticles

(2016) Lin Jiang et al.   ACTA MATERIALIA

Deformation and strengthening mechanisms of a carbon nanotube reinforced aluminum composite

(2016) F. Mokdad et al.   CARBON

Effects of TiB 2 particles on microstructure and mechanical properties of an in-situ TiB 2 -Al–Cu–Li matrix composite

(2016) Yanwei Shen et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Enhanced mechanical properties of Al5083 alloy with graphene nanoplates prepared by ball milling and hot extrusion

(2016) Haiping Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Back stress strengthening and strain hardening in gradient structure

(2016) Muxin Yang et al.   Materials Research Letters

Effects of mold temperature on the microstructure and tensile properties of SiC p /2024 Al-based composites fabricated via powder thixoforming

(2016) P.B. Li et al.   MATERIALS & DESIGN

Graphene nanoplatelets induced heterogeneous bimodal structural magnesium matrix composites with enhanced mechanical properties

(2016) Shulin Xiang et al.   Scientific Reports

Fabrication of Nanocarbon Composites Using In Situ Chemical Vapor Deposition and Their Applications

(2015) Chunnian He et al.   ADVANCED MATERIALS

Synergistic effect of CNTs reinforcement and precipitation hardening in in-situ CNTs/Al–Cu composites

(2015) Xin Meng et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure and tensile properties of bulk nanostructured aluminum/graphene composites prepared via cryomilling

(2015) J.L. Li et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Enhanced Mechanical Properties of Graphene (Reduced Graphene Oxide)/Aluminum Composites with a Bioinspired Nanolaminated Structure

(2015) Zan Li et al.   NANO LETTERS

Heterogeneous lamella structure unites ultrafine-grain strength with coarse-grain ductility

(2015) Xiaolei Wu et al.   PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA

Effect of ball milling on graphene reinforced Al6061 composite fabricated by semi-solid sintering

(2014) Mina Bastwros et al.   COMPOSITES PART B-ENGINEERING

Harmonic-structured copper: performance and proof of fabrication concept based on severe plastic deformation of powders

(2014) Choncharoen Sawangrat et al.   JOURNAL OF MATERIALS SCIENCE

Improvement of mechanical properties in SUS304L steel through the control of bimodal microstructure characteristics

(2014) Zhe Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

The Development of High Performance Ti-6Al-4V Alloy via a Unique Microstructural Design with Bimodal Grain Size Distribution

(2014) Sanjay Kumar Vajpai et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Uniform dispersion of graphene oxide in aluminum powder by direct electrostatic adsorption for fabrication of graphene/aluminum composites

(2014) Zan Li et al.   NANOTECHNOLOGY

Improving the tensile ductility and uniform elongation of high-strength ultrafine-grained Al alloys by lowering the grain boundary misorientation angle

(2014) T. Hu et al.   SCRIPTA MATERIALIA

Fabrication of carbon nanotube reinforced Al composites with well-balanced strength and ductility

(2013) Xudong Yang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions

(2013) Taku Sakai et al.   PROGRESS IN MATERIALS SCIENCE

Strengthening effect of single-atomic-layer graphene in metal–graphene nanolayered composites

(2013) Youbin Kim et al.   Nature Communications

Strong and ductile carbon nanotube/aluminum bulk nanolaminated composites with two-dimensional alignment of carbon nanotubes

(2011) Lin Jiang et al.   SCRIPTA MATERIALIA

An enhanced FEM model for particle size dependent flow strengthening and interface damage in particle reinforced metal matrix composites

(2010) J.C. Shao et al.   COMPOSITES SCIENCE AND TECHNOLOGY

Evolution of the Raman spectra from single-, few-, and many-layer graphene with increasing disorder

(2010) E. H. Martins Ferreira et al.   PHYSICAL REVIEW B

An enhanced continuum model for size-dependent strengthening and failure of particle-reinforced composites

(2009) Yeong Sung Suh et al.   ACTA MATERIALIA

New Microstructure Design for Commercially Pure Titanium with Outstanding Mechanical Properties by Mechanical Milling and Hot Roll Sintering

(2009) Tatsuya Sekiguchi et al.   MATERIALS TRANSACTIONS

Measurement of the Elastic Properties and Intrinsic Strength of Monolayer Graphene

(2008) C. Lee et al.   SCIENCE

Raman Spectra of Graphite Oxide and Functionalized Graphene Sheets

(2007) Konstantin N. Kudin et al.   NANO LETTERS