Exceptional mechanical properties of aluminum matrix composites with heterogeneous structure induced by in-situ graphene nanosheet-Cu hybrids
出版年份 2022 全文链接
标题
Exceptional mechanical properties of aluminum matrix composites with heterogeneous structure induced by in-situ graphene nanosheet-Cu hybrids
作者
关键词
Aluminum matrix composites (AMCs), Heterogeneous structure, In-situ graphene nanosheet-Cu (GNS-Cu), Strengthening, Toughening
出版物
COMPOSITES PART B-ENGINEERING
Volume 234, Issue -, Pages 109731
出版商
Elsevier BV
发表日期
2022-02-10
DOI
10.1016/j.compositesb.2022.109731
参考文献
相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。- Simultaneously enhanced strength and ductility of Al matrix composites through the introduction of intragranular nano-sized graphene nanoplates
- (2021) Tielong Han et al. COMPOSITES PART B-ENGINEERING
- Achieving prominent strengthening efficiency of graphene nanosheets in Al matrix composites by hybrid deformation
- (2021) Bowen Pu et al. CARBON
- Improving the high-cycle fatigue strength of heterogeneous carbon nanotube/Al-Cu-Mg composites through grain size design in ductile-zones
- (2021) K. Ma et al. COMPOSITES PART B-ENGINEERING
- Hierarchical microstructure architecture: A roadmap towards strengthening and toughening reduced graphene oxide/2024Al matrix composites synthesized by flake powder thixoforming
- (2020) Pubo Li et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Microstructures and mechanical properties of an Al-Cu-Mg-Sc alloy reinforced with in-situ TiB2 particulates
- (2020) Siming Ma et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- The superior mechanical and physical properties of nanocarbon reinforced bulk composites achieved by architecture design – A review
- (2020) Xiang Zhang et al. PROGRESS IN MATERIALS SCIENCE
- Trimodal grain structure enables high-strength CNT/Al-Cu-Mg composites higher ductility by powder assembly & alloying
- (2020) Xiaowen Fu et al. Materials Research Letters
- Heterostructured materials: superior properties from hetero-zone interaction
- (2020) Yuntian Zhu et al. Materials Research Letters
- Revealing the strengthening and toughening mechanisms of Al-CuO composite fabricated via in-situ solid-state reaction
- (2020) Xudong Rong et al. ACTA MATERIALIA
- Perspective on hetero-deformation induced (HDI) hardening and back stress
- (2019) Yuntian Zhu et al. Materials Research Letters
- Bioinspired, graphene-enabled Ni composites with high strength and toughness
- (2019) Yunya Zhang et al. Science Advances
- High-temperature mechanical properties of 2024 Al matrix nanocomposite reinforced by TiC network architecture
- (2019) Huabing Yang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- High-strength graphene network reinforced copper matrix composites achieved by architecture design and grain structure regulation
- (2019) Xiang Zhang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Effects of Microstructure on Mechanical Properties of Harmonic Structure Designed Pure Ni
- (2019) Masaya Nagata et al. MATERIALS TRANSACTIONS
- A novel method for preparing graphene nanosheets/Al composites by accumulative extrusion-bonding process
- (2019) Gaohui Wu et al. CARBON
- Manipulating the plastic strain delocalization through ultra-thinned hierarchical design for strength-ductility synergy
- (2019) Hao Wu et al. SCRIPTA MATERIALIA
- Enhancement of the strength-ductility relationship for carbon nanotube/Al–Cu–Mg nanocomposites by material parameter optimisation
- (2019) Z.Y. Liu et al. CARBON
- Extraordinary reinforcing effect of carbon nanotubes in aluminium matrix composites assisted by in-situ alumina nanoparticles
- (2019) B. Chen et al. COMPOSITES PART B-ENGINEERING
- Microstructure and properties of copper coated graphene nanoplates reinforced Al matrix composites developed by low temperature ball milling
- (2019) Tielong Han et al. CARBON
- Stress relaxation and the cellular structure-dependence of plastic deformation in additively manufactured AlSi10Mg alloys
- (2019) Zan Li et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Microstructural evolution and deformation behavior of Al-Cu alloys: A Transmission X-ray Microscopy (TXM) and micropillar compression study
- (2018) C. Shashank Kaira et al. ACTA MATERIALIA
- Interface structure and strengthening behavior of graphene/CuCr composites
- (2018) Ke Chu et al. CARBON
- Tailoring the structure and mechanical properties of graphene nanosheet/aluminum composites by flake powder metallurgy via shift-speed ball milling
- (2018) Yuanyuan Jiang et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Microstructure and tensile properties of 5083 Al matrix composites reinforced with graphene oxide and graphene nanoplates prepared by pressure infiltration method
- (2018) Puzhen Shao et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Creation of individual few-layer graphene incorporated in an aluminum matrix
- (2018) Weiwei Zhou et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Interface affected zone for optimal strength and ductility in heterogeneous laminate
- (2018) C.X. Huang et al. Materials Today
- Graphene defect engineering for optimizing the interface and mechanical properties of graphene/copper composites
- (2018) Ke Chu et al. CARBON
- High strength and ductility of graphene-like carbon nanosheet/copper composites fabricated directly from commercial oleic acid coated copper powders
- (2018) Ziyue Yang et al. Nanoscale
- Effect of Interface Structure on the Mechanical Properties of Graphene Nanosheets Reinforced Copper Matrix Composites
- (2018) Xiang Zhang et al. ACS Applied Materials & Interfaces
- Effect of ball milling time on graphene nanosheets reinforced Al6063 composite fabricated by pressure infiltration method
- (2018) Zhenhe Yu et al. CARBON
- In situ synthesis of copper-modified graphene-reinforced aluminum nanocomposites with balanced strength and ductility
- (2018) Jie Wang et al. JOURNAL OF MATERIALS SCIENCE
- Enhanced strength and ductility in ZrB2/2024Al nanocomposite with a quasi-network architecture
- (2018) Z.Y. Zhang et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Creating defects on graphene basal-plane toward interface optimization of graphene/CuCr composites
- (2018) Ke Chu et al. CARBON
- Enhancement of strength-ductility trade-off in a high-entropy alloy through a heterogeneous structure
- (2018) S.W. Wu et al. ACTA MATERIALIA
- The fabrication of graphene-reinforced Al-based nanocomposites using high-pressure torsion
- (2018) Yi Huang et al. ACTA MATERIALIA
- Interfacial reaction induced efficient load transfer in few-layer graphene reinforced Al matrix composites for high-performance conductor
- (2018) Weiwei Zhou et al. COMPOSITES PART B-ENGINEERING
- Effect of carbon nanotubes and high temperature extrusion on the microstructure evolution of Al-Cu alloy
- (2017) Chunhong Li et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Lateral size effect of graphene on mechanical properties of aluminum matrix nanolaminated composites
- (2017) Mei Zhao et al. SCRIPTA MATERIALIA
- Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloy
- (2017) Y. H. Jo et al. Nature Communications
- Back stress in strain hardening of carbon nanotube/aluminum composites
- (2017) Run Xu et al. Materials Research Letters
- Heterogeneous materials: a new class of materials with unprecedented mechanical properties
- (2017) Xiaolei Wu et al. Materials Research Letters
- Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al–Zn–Mg alloys
- (2016) Kaka Ma et al. ACTA MATERIALIA
- Mechanical properties of copper/bronze laminates: Role of interfaces
- (2016) Xiaolong Ma et al. ACTA MATERIALIA
- Toughening of aluminum matrix nanocomposites via spatial arrays of boron carbide spherical nanoparticles
- (2016) Lin Jiang et al. ACTA MATERIALIA
- Deformation and strengthening mechanisms of a carbon nanotube reinforced aluminum composite
- (2016) F. Mokdad et al. CARBON
- Effects of TiB 2 particles on microstructure and mechanical properties of an in-situ TiB 2 -Al–Cu–Li matrix composite
- (2016) Yanwei Shen et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Enhanced mechanical properties of Al5083 alloy with graphene nanoplates prepared by ball milling and hot extrusion
- (2016) Haiping Zhang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Back stress strengthening and strain hardening in gradient structure
- (2016) Muxin Yang et al. Materials Research Letters
- Effects of mold temperature on the microstructure and tensile properties of SiC p /2024 Al-based composites fabricated via powder thixoforming
- (2016) P.B. Li et al. MATERIALS & DESIGN
- Graphene nanoplatelets induced heterogeneous bimodal structural magnesium matrix composites with enhanced mechanical properties
- (2016) Shulin Xiang et al. Scientific Reports
- Fabrication of Nanocarbon Composites Using In Situ Chemical Vapor Deposition and Their Applications
- (2015) Chunnian He et al. ADVANCED MATERIALS
- Synergistic effect of CNTs reinforcement and precipitation hardening in in-situ CNTs/Al–Cu composites
- (2015) Xin Meng et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Microstructure and tensile properties of bulk nanostructured aluminum/graphene composites prepared via cryomilling
- (2015) J.L. Li et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Enhanced Mechanical Properties of Graphene (Reduced Graphene Oxide)/Aluminum Composites with a Bioinspired Nanolaminated Structure
- (2015) Zan Li et al. NANO LETTERS
- Heterogeneous lamella structure unites ultrafine-grain strength with coarse-grain ductility
- (2015) Xiaolei Wu et al. PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA
- Effect of ball milling on graphene reinforced Al6061 composite fabricated by semi-solid sintering
- (2014) Mina Bastwros et al. COMPOSITES PART B-ENGINEERING
- Harmonic-structured copper: performance and proof of fabrication concept based on severe plastic deformation of powders
- (2014) Choncharoen Sawangrat et al. JOURNAL OF MATERIALS SCIENCE
- Improvement of mechanical properties in SUS304L steel through the control of bimodal microstructure characteristics
- (2014) Zhe Zhang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- The Development of High Performance Ti-6Al-4V Alloy via a Unique Microstructural Design with Bimodal Grain Size Distribution
- (2014) Sanjay Kumar Vajpai et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Uniform dispersion of graphene oxide in aluminum powder by direct electrostatic adsorption for fabrication of graphene/aluminum composites
- (2014) Zan Li et al. NANOTECHNOLOGY
- Improving the tensile ductility and uniform elongation of high-strength ultrafine-grained Al alloys by lowering the grain boundary misorientation angle
- (2014) T. Hu et al. SCRIPTA MATERIALIA
- Fabrication of carbon nanotube reinforced Al composites with well-balanced strength and ductility
- (2013) Xudong Yang et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions
- (2013) Taku Sakai et al. PROGRESS IN MATERIALS SCIENCE
- Strengthening effect of single-atomic-layer graphene in metal–graphene nanolayered composites
- (2013) Youbin Kim et al. Nature Communications
- Strong and ductile carbon nanotube/aluminum bulk nanolaminated composites with two-dimensional alignment of carbon nanotubes
- (2011) Lin Jiang et al. SCRIPTA MATERIALIA
- An enhanced FEM model for particle size dependent flow strengthening and interface damage in particle reinforced metal matrix composites
- (2010) J.C. Shao et al. COMPOSITES SCIENCE AND TECHNOLOGY
- Evolution of the Raman spectra from single-, few-, and many-layer graphene with increasing disorder
- (2010) E. H. Martins Ferreira et al. PHYSICAL REVIEW B
- An enhanced continuum model for size-dependent strengthening and failure of particle-reinforced composites
- (2009) Yeong Sung Suh et al. ACTA MATERIALIA
- New Microstructure Design for Commercially Pure Titanium with Outstanding Mechanical Properties by Mechanical Milling and Hot Roll Sintering
- (2009) Tatsuya Sekiguchi et al. MATERIALS TRANSACTIONS
- Measurement of the Elastic Properties and Intrinsic Strength of Monolayer Graphene
- (2008) C. Lee et al. SCIENCE
- Raman Spectra of Graphite Oxide and Functionalized Graphene Sheets
- (2007) Konstantin N. Kudin et al. NANO LETTERS
Add your recorded webinar
Do you already have a recorded webinar? Grow your audience and get more views by easily listing your recording on Peeref.
Upload NowAsk a Question. Answer a Question.
Quickly pose questions to the entire community. Debate answers and get clarity on the most important issues facing researchers.
Get Started