Cobalt thin films as water-recombination electrocatalysts

Catalysts and electmcatalysts are crucial for energy production and storage. To develop cost-efficient systems taking advantage of functionalized surfaces, the catalysts can be synthesized as nanomaterials or thin films. In this work, cobalt thin films were deposited on low-alloyed steel using magnetron sputtering. The films are uniform with a smooth surface and a thickness of similar to 400 nm. The films were electrochemically oxidized via anodization to a mix of cobalt oxides, one of them being Co3O4, at room temperature in an alkaline solution. The electrocatalytic performances of the anodized films were evaluated in 1 M KOH electrolyte saturated with oxygen. Cathodic currents in -0.5 mA/cm(2) range, corresponding to oxygen reduction reaction (ORR) activity, were measured with cyclic voltammetry. The catalytic activity of the films was evaluated as a function of time. The anodized Co coating exhibited three times higher activity than the steel substrate. The kinetics for the ORR were evaluated through Tafel plots and a slope of 226 mV/decade was found. Post-ORR characterization of the films revealed hexagonal plate-like oxide particles on the surface. After 50 cyclic voltammograms, the film was further oxidized, indicating that the ORR activity also affects the overall surface state of the film. This study demonstrates that thin films, after electrochemical modification, can be electrocatalysts for the oxygen reduction reaction and potentially used for applications in energy production and storage.