Investigation on laser-induced oxidation assisted micro-milling of Inconel 718

Feasibility study of the Ti(C7N3)-based cermet micro-mill based on dynamic fatigue behavior and modeling of the contact stress distribution on the round cutting edge

(2019) Yishun Wang et al.   INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES

Tool wear mechanisms and micro-channels quality in micro-machining of Ti-6Al-4V alloy using the Ti(C7N3)-based cermet micro-mills

(2019) Yishun Wang et al.   TRIBOLOGY INTERNATIONAL

Effect of the progressive tool wear on surface topography and chip formation in micro-milling of Ti–6Al–4V using Ti(C7N3)-based cermet micro-mill

(2019) Yishun Wang et al.   TRIBOLOGY INTERNATIONAL

Laser micro-milling of bio-lox forte ceramic: An experimental analysis

(2018) Basem M.A. Abdo et al.   PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY

Coupled thermal and mechanical analyses of micro-milling Inconel 718

(2018) Xiaohong Lu et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Model for the prediction of 3D surface topography and surface roughness in micro-milling Inconel 718

(2017) Xiaohong Lu et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Fabrication and machining of ceramic composites — A review on current scenario

(2017) Mandeep Singh Rayat et al.   MATERIALS AND MANUFACTURING PROCESSES

Micro-electrical discharge machining of difficult-to-machine materials: A review

(2017) Ved Prakash et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Influence of cutting tool geometrical parameters on tool wear in high-speed milling of Inconel 718 curved surface

(2017) Jian-wei Ma et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Fabrication of stepped hole on zirconia bioceramics by ultrasonic machining

(2016) S. Das et al.   MACHINING SCIENCE AND TECHNOLOGY

Review on powder-bed laser additive manufacturing of Inconel 718 parts

(2016) Xiaoqing Wang et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Optimization of machining parameters during micro-milling of Ti6Al4V titanium alloy and Inconel 718 materials using Taguchi method

(2016) Emel Kuram et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Experimental investigation and processing optimization for micro-milling of copper clad polyimide

(2016) Kai Zhao et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Fabrication of micro-pin array with high aspect ratio on stainless steel using nanosecond laser beam machining

(2012) Se Won Lee et al.   APPLIED SURFACE SCIENCE

Wear behavior of coated tools in laser assisted micro-milling of hardened steel

(2012) Mukund Kumar et al.   WEAR

Process capability study of laser assisted micro milling of a hard-to-machine material

(2011) Mukund Kumar et al.   Journal of Manufacturing Processes

Laser assisted micro-milling of hard-to-machine materials

(2009) S. Melkote et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY