Microcracks in ultrabasic rocks under uniaxial compressive stress

The initiation and propagation of microcracks under stress are highly dependent upon the mineralogical and textural characteristics of the various lithotypes. Detailed observation and quantification of microcracks before and after uniaxial compression test were conducted. A fresh olivine-rich harzburgite and a serpentinized dunite were analyzed, collected from the Pindos and Vourinos ophiolites (northern Greece) respectively, in order to compare their microcrack patterns. Quantitative analysis indicated that during uniaxial compression the intragranular microcracks, which are the dominating crack-type, are gradually transformed or organized into transgranular cracks. Some of the newly formed transgranular cracks may also be a result of the growth of existing grain-boundary cracks. The new intragranular microcracks in the olivine-rich harzburgite are oriented predominantly parallel to the compressive stress direction, while those in the serpentinized dunite show a scattered orientation presumably due to the mesh texture of this rock-type. The new transgranular cracks of both peridotites tend to be subparallel to the compressive stress direction, however, many of them show a random orientation due to the fact that they have been formed as a result of the propagation of grain-boundary cracks. The occurrence of the soft serpentine along fracture surfaces of olivine, when it is in assemblage with orthopyroxene, tends to absorb the applied stress hampering the development of microcracks in olivine. On the other hand in serpentinized peridotites, the microcracks are enhanced in olivine because it is surrounded by large amounts of the much softer and flexible serpentine. Microcracks are usually formed along the cleavage planes of orthopyroxene porphyroclasts, indicating that such crystallographic preferred orientations act as planes of weakness, controlling the direction of the crack paths. Cr-spinel grains likely comprise locations of initiation of microcracks due to their very hard nature and different mechanical behaviour relative to the surrounding silicate phases. Knowledge of the mineralogical and textural characteristics may assist in the prediction of potential development of failure surfaces of an ultrabasic rock in-service. (C) 2010 Elsevier B.V. All rights reserved.