Quantifying engineering parameters of expansive soils from their reflectance spectra

Occurrence of expansive soils in construction sites has serious implications on planning, design, construction, maintenance. and overall performance especially of lightweight engineering infrastructures. Such soils are particularly susceptible to large volume changes in response to moisture content fluctuations following seasonal climatic variations. This can lead to deformation of structures built up on them. For this study, soil samples were collected from the eastern part of Addis Ababa. Specific expansive soil engineering parameters namely: Atterberg limits (LL, PL and PI), free swell and cation exchange capacity were measured in a soil mechanics laboratory. Reflectance spectra of each soil sample were acquired in a remote sensing laboratory using ASD fieldspec full range spectrometer. A multivariate calibration method, partial least squares regression (PLSR) analysis, through simple wavelength approach, was used to construct empirical prediction models for estimating engineering parameters of expansive soils from their respective reflectance spectra. Correlation coefficients of 0.90, 0.87, 0.71, 0.81 and 0.71 for CEC, LL, PL PI and FS respectively were obtained. The correlation coefficients showed that large portion of variations in engineering parameters of expansive soils could be accounted for by spectral parameters. Apart from these high correlation coefficients, small root mean square errors of calibration (RMSEC) and prediction (RMSEP), standard error of calibration (SEC) and prediction (SEP) and minimum bias were obtained. The results indicate potential of spectroscopy in deriving engineering parameters of expansive soils from their respective reflectance spectra and hence, its potential applicability in supporting geotechnical investigations of such soils. (C) 2009 Elsevier B.V. All rights reserved.