Predicting Powder-Polymer Mixture Properties for PIM Design

Measurements of Powder–Polymer Mixture Properties and Their Use in Powder Injection Molding Simulations for Aluminum Nitride

(2012) Kunal H. Kate et al.   JOM

Highly conducting poly(methyl methacrylate)/carbon nanotubes composites: Investigation on their thermal, dynamic-mechanical, electrical and dielectric properties

(2011) E. Logakis et al.   COMPOSITES SCIENCE AND TECHNOLOGY

Zirconium tungstate/cyanate ester nanocomposites with tailored thermal expansivity

(2011) Prashanth Badrinarayanan et al.   COMPOSITES SCIENCE AND TECHNOLOGY

Experimental investigation of heat conduction in polyester–Al2O3 and polyester–CuO nanocomposites

(2011) D.C. Moreira et al.   EXPERIMENTAL THERMAL AND FLUID SCIENCE

Analytical interpretations of structural and mechanical response of high density polyethylene/hydroxyapatite bio-composites

(2011) Harjeet S. Jaggi et al.   MATERIALS & DESIGN

The effect of filler on the temperature coefficient of the relative permittivity of PTFE/ceramic composites

(2011) S. Rajesh et al.   PHYSICA B-CONDENSED MATTER

Thermal properties of silicon powder filled high-density polyethylene composites

(2010) T.K. Dey et al.   THERMOCHIMICA ACTA

Viscoelastic properties and characterization of inorganic particulate-filled polymer composites

(2009) J. Z. Liang   JOURNAL OF APPLIED POLYMER SCIENCE

Influence of the filler content on the thermal expansion behavior of an epoxy matrix particulate composite

(2009) S. Tognana et al.   Materials Science and Engineering B-Advanced Functional Solid-State Materials

Effect of powders and binders on material properties and molding parameters in iron and stainless steel powder injection molding process

(2009) Seokyoung Ahn et al.   POWDER TECHNOLOGY

Preparation and properties of hollow glass microsphere-filled epoxy-matrix composites

(2008) K YUNG et al.   COMPOSITES SCIENCE AND TECHNOLOGY

Thermal properties of polytetrafluoroethylene/Sr2Ce2Ti5O16 polymer/ceramic composites

(2008) G. Subodh et al.   JOURNAL OF APPLIED POLYMER SCIENCE

Thermal Properties of Heat Conductive Silicone Rubber Filled with Hybrid Fillers

(2008) Wenying Zhou et al.   JOURNAL OF COMPOSITE MATERIALS

Optimisation of process conditions in powder injection moulding of microsystem components using a robust design method: part I. primary design parameters

(2008) R. Urval et al.   POWDER METALLURGY

Optimisation of process conditions in powder injection moulding of microsystem components using robust design method Part 2 – Secondary design parameters

(2008) R. Urval et al.   POWDER METALLURGY

Investigation of the thermal, mechanical, and fracture properties of alumina–epoxy composites

(2007) Laura M. McGrath et al.   POLYMER