Novel approaches for the accumulation of oxygenated intermediates to multi-millimolar concentrations

Metalloenzymes that utilize molecular oxygen as a co-substrate catalyze a wide variety of chemically difficult oxidation reactions. Significant insight into the reaction mechanisms of these enzymes can be obtained by the application of a combination of rapid kinetic and spectroscopic methods to the direct structural characterization of intermediate states. A key limitation of this approach is the low aqueous solubility (<2 mM) of the co-substrate, O-2, which undergoes further dilution (typically by one-third or one-half) upon initiation of reactions by rapid-mixing. This situation imposes a practical upper limit on [O-2] (and therefore on the concentration of reactive intermediate(s) that can be rapidly accumulated) of similar to 1-1.3 mM in such experiments as they are routinely carried out. However, many spectroscopic methods benefit from or require significantly greater concentrations of the species to be studied. To overcome this problem, we have recently developed two new approaches for the preparation of samples of oxygenated intermediates: (1) direct oxygenation of reduced metalloenzymes using gaseous O-2 and (2) the in situ generation of O-2 from chlorite catalyzed by the enzyme chlorite dismutase (Cld). Whereas the former method is applicable only to intermediates with half lives of several minutes, owing to the sluggishness of transport of O-2 across the gas-liquid interface, the latter approach has been successfully applied to trap several intermediates at high concentration and purity by the freeze-quench method. The in situ approach permits generation of a pulse of at least 5 mM O-2 within similar to 1 ms and accumulation of O-2 to effective concentrations of up to similar to 11 mM (i.e. similar to 10-fold greater than by the conventional approach). The use of these new techniques for studies of oxygenases and oxidases is discussed. (C) 2012 Elsevier B.V. All rights reserved.