Combination of Different In Situ Characterization Techniques and Scanning Electron Microscopy Investigations for a Comprehensive Description of the Tensile Deformation Behavior of a CrMnNi TRIP/TWIP Steel

Microstructural evolution and the variation of tensile behavior after aging heat treatment of precipitation hardened martensitic steel

(2015) Jong-Ho Shin et al.   MATERIALS CHARACTERIZATION

Magnitude of shear of deformation-induced α′-martensite in high-alloy metastable steel

(2015) Anja Weidner et al.   MATERIALS LETTERS

In-situ strain localization analysis in low density transformation-twinning induced plasticity steel using digital image correlation

(2015) M. Eskandari et al.   OPTICS AND LASERS IN ENGINEERING

Case studies on the application of high-resolution electron channelling contrast imaging – investigation of defects and defect arrangements in metallic materials

(2015) Anja Weidner et al.   PHILOSOPHICAL MAGAZINE

Theory and application of electron channelling contrast imaging under controlled diffraction conditions

(2014) Stefan Zaefferer et al.   ACTA MATERIALIA

Study the effect of martensite banding on the failure initiation in dual-phase steel

(2014) A. Ramazani et al.   COMPUTATIONAL MATERIALS SCIENCE

Biaxial in-phase and out-of-phase cyclic deformation and fatigue behavior of an austenitic TRIP steel

(2014) Stephanie Ackermann et al.   INTERNATIONAL JOURNAL OF FATIGUE

Strain localization and damage in dual phase steels investigated by coupled in-situ deformation experiments and crystal plasticity simulations

(2014) C.C. Tasan et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Deformation mechanisms in austenitic TRIP/TWIP steels at room and elevated temperature investigated by acoustic emission and scanning electron microscopy

(2014) M. Linderov et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Low temperature tensile deformation and acoustic emission signal characteristics of AISI 304LN stainless steel

(2014) K. Barat et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Relationship between acoustic emission energy and the kinetics of martensite formation in plain carbon steels

(2014) S.M.C. van Bohemen   PHILOSOPHICAL MAGAZINE

Nanoindentation measurements on deformation-induced α’-martensite in a metastable austenitic high-alloy CrMnNi steel

(2014) Anja Weidner et al.   PHILOSOPHICAL MAGAZINE LETTERS

Accurate electron channeling contrast analysis of dislocations in fine grained bulk materials

(2014) H. Mansour et al.   SCRIPTA MATERIALIA

Stacking fault energy in austenitic steels determined by usingin situX-ray diffraction during bending

(2014) D. Rafaja et al.   JOURNAL OF APPLIED CRYSTALLOGRAPHY

Kinetics of deformation processes in high-alloyed cast transformation-induced plasticity/twinning-induced plasticity steels determined by acoustic emission and scanning electron microscopy: Influence of austenite stability on deformation mechanisms

(2013) A. Vinogradov et al.   ACTA MATERIALIA

Microstructure Defects Contributing to the Energy Absorption in CrMnNi TRIP Steels

(2013) Daria Borisova et al.   ADVANCED ENGINEERING MATERIALS

Failure mechanisms in DP600 steel: Initiation, evolution and fracture

(2013) H. Ghadbeigi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ultrafine grained high-alloyed austenitic TRIP steel

(2013) A. Weidner et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A real-time approach to acoustic emission clustering

(2013) Eraldo Pomponi et al.   MECHANICAL SYSTEMS AND SIGNAL PROCESSING

Strain localization behavior in low-carbon martensitic steel during tensile deformation

(2013) Hyuntaek Na et al.   SCRIPTA MATERIALIA

Nanoindentation investigation on the mechanical stability of individual austenite grains in a medium-Mn transformation-induced plasticity steel

(2013) B.B. He et al.   SCRIPTA MATERIALIA

Influence of carbon content on the microstructure, martensitic transformation and mechanical properties in austenite/ε-martensite dual-phase Fe–Mn–C steels

(2012) Jae-Bok Seol et al.   ACTA MATERIALIA

Quantitative Studies of microstructural phase transformation in Nickel–Titanium

(2012) M. Kimiecik et al.   MATERIALS LETTERS

Plastic strain localization and fatigue micro-crack formation in Hastelloy X

(2012) Wael Abuzaid et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

In situ nanoindentation: Probing nanoscale multifunctionality

(2012) Hussein Nili et al.   PROGRESS IN MATERIALS SCIENCE

SEM Investigation of High-Alloyed Austenitic Stainless Cast Steels With Varying Austenite Stability at Room Temperature and 100°C

(2012) Horst Biermann et al.   STEEL RESEARCH INTERNATIONAL

A simple method for residual stress measurements in thin films by means of focused ion beam milling and digital image correlation

(2012) M. Krottenthaler et al.   SURFACE & COATINGS TECHNOLOGY

In situ X-ray diffraction study of stacking fault formation in the near-surface region of transformation induced plasticity steels

(2012) David Rafaja et al.   THIN SOLID FILMS

Design of a novel Mn-based 1GPa duplex stainless TRIP steel with 60% ductility by a reduction of austenite stability

(2011) C. Herrera et al.   ACTA MATERIALIA

Surface Decoration for Improving the Accuracy of Displacement Measurements by Digital Image Correlation in SEM

(2011) B. Winiarski et al.   EXPERIMENTAL MECHANICS

Stacking fault model of ∊-martensite and itsDIFFaXimplementation

(2011) Stefan Martin et al.   JOURNAL OF APPLIED CRYSTALLOGRAPHY

State-of-the-knowledge on TWIP steel

(2011) B C De Cooman et al.   MATERIALS SCIENCE AND TECHNOLOGY

Constitutive Modeling of the Tensile Behavior of Al-TWIP Steel

(2011) Jinkyung Kim et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Strain Rate Effect on Material Behavior of TRIP-Steel/Zirconia Honeycomb Structures

(2011) D. Ehinger et al.   STEEL RESEARCH INTERNATIONAL

Influence of Manganese and Nickel on the α´ Martensite Transformation Temperatures of High Alloyed Cr-Mn-Ni Steels

(2011) Andreas Jahn et al.   STEEL RESEARCH INTERNATIONAL

Cyclic Deformation Behaviour of Three Austenitic Cast CrMnNi TRIP/TWIP Steels with Various Ni Content

(2011) A. Glage et al.   STEEL RESEARCH INTERNATIONAL

On the mechanism of twin formation in Fe–Mn–C TWIP steels

(2010) H. Idrissi et al.   ACTA MATERIALIA

In situ electron backscatter diffraction (EBSD) during the compression of micropillars

(2010) C. Niederberger et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of grain refinement to 1μm on strength and toughness of dual-phase steels

(2010) Marion Calcagnotto et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Characterisation of the Portevin-Le Châtelier effect affecting an austenitic TWIP steel based on digital image correlation

(2010) K. Renard et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Local plastic strain evolution in a high strength dual-phase steel

(2010) H. Ghadbeigi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Stacking faults in high-alloyed metastable austenitic cast steel observed by electron channelling contrast imaging

(2010) A. Weidner et al.   SCRIPTA MATERIALIA

Temperature Depending Influence of the Martensite Formation on the Mechanical Properties of High-Alloyed Cr-Mn-Ni As-Cast Steels

(2010) Andreas Jahn et al.   STEEL RESEARCH INTERNATIONAL

Multiscale strain measurements of plastically deforming polycrystalline titanium: Role of deformation heterogeneities

(2009) C. Efstathiou et al.   INTERNATIONAL JOURNAL OF PLASTICITY

In situ SEM indentation experiments: Instruments, methodology, and applications

(2009) Rudy Ghisleni et al.   MICROSCOPY RESEARCH AND TECHNIQUE

In situ mechanical observations during nanoindentation inside a high-resolution scanning electron microscope

(2008) K.A. Rzepiejewska-Malyska et al.   JOURNAL OF MATERIALS RESEARCH

In-situ SEM indentation studies of the deformation mechanisms in TiN, CrN and TiN/CrN

(2008) K. Rzepiejewska-Malyska et al.   MICRON

An alternative model for the strain hardening of FCC alloys that twin, validated for twinning-induced plasticity steel

(2008) J GILSEVILLANO   SCRIPTA MATERIALIA

Effect of grain and twin boundaries on the hardening mechanisms of twinning-induced plasticity steels

(2007) O. Bouaziz et al.   SCRIPTA MATERIALIA