Dynamics of contaminants in phosphogypsum of the fertilizer industry of Huelva (SW Spain): From phosphate rock ore to the environment

The dynamics of trace elements from phosphate rock ore to the environment in a phosphoric acid plant located in SW Spain and the impact of phosphogypsum wastes were investigated through total digestion and BCR-sequential extraction. Based on total concentration, element transfer factors as criteria for examining the potential environmental risk of waste with respect to ore rock were calculated, and it was observed that most trace elements are only transferred into phosphogypsum at rates of 2-12%. However, based on those concentrations that are likely to be most readily mobile in the environment, phosphogypsum acts as a higher emission source of contaminants than the original rock. About 100 million tonnes of phosphogypsum are stack-piled in a dump of 1200 ha over salt-marshes of an estuary formed by the confluence of the Tinto and Odiel rivers. Phosphogypsum has been applied, at the recommended rate of 20-25 t/ha since 1978-2001, to improve fertility and reduce Na saturation in agricultural soils of the Guadalquivir river valley (140 km(2)). Phosphogypsum capacity as a source of mobile contaminants in three environmental scenarios (water leaching, exposure to oxidising and reducing conditions) was quantified by combining sequential extraction and waste mass. The amounts of mobile contaminants that could be released for every tonne of phosphogypsum are approximately 7 x 10(2) g Sr, 1.1 x 10(2) g Fe, 55 g Y, 30 g Ce, 12 g Cr, 11 g Ti, 5 g Zn, 4 g each of Cu and Pb, 3 g each of V and Cd, 2 g each of As and Ni and 1 g U. Multiplying these amounts by 100 Mt and 20-25 t/ha, it is possible to calculate risk assessments of phosphogypsum for both estuarine zones, e.g. in a hypothetical stack collapse and waste spilling, and agricultural soils, respectively. (C) 2010 Elsevier Ltd. All rights reserved.