Journal
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
Volume 90, Issue -, Pages 1197-1206Publisher
PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.ijheatmasstransfer.2015.07.065
Keywords
Heat transfer augmentation; Triangular duct; Nanofluids; Vortex
Categories
Funding
- Department of Mechanical Engineering, Universiti Tenaga Nasional
Ask authors/readers for more resources
This study presents the effect of nanofluid and vortex generators compound on heat transfer and friction factor in an equilateral triangular duct experimentally. Two different types of nanofluids namely, Al2O3 and SiO2 nanoparticles suspended in distilled water (DW) with two particle concentrations were successfully prepared and tested. A wide range of Reynolds number was covered from 500 to 8000, approximately. The results of smooth triangular duct using water as a working fluid were validated with literatures and a good agreement was obtained. The present results show a good enhancement in heat transfer by using vortex generator with base fluid while a significant enhancement was registered by using the compound of vortex generator and nanofluids accomplished with a moderate increase in the friction factor. The maximum enhancement in the Nusselt number obtained in this study is 44.64% and 41,82% at 1 vol.% and Re approximate to 4000 for SiO2-DW and Al2O3-DW nanofluid, respectively. (C) 2015 Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available