4.7 Article

Shear stress in the graphitization of carbonaceous matter during the low-grade metamorphism from the northern Parang Mountains (South Carpathians) - Implications to graphite geothermometry

Journal

INTERNATIONAL JOURNAL OF COAL GEOLOGY
Volume 146, Issue -, Pages 179-187

Publisher

ELSEVIER
DOI: 10.1016/j.coal.2015.05.008

Keywords

Carbonaceous matter; Graphitization; Crystallinity degree; Strain; Geothermometry; Graphite geothermometer

Funding

  1. National University Research Council from Romania [118,12613-1]

Ask authors/readers for more resources

Low-grade metamorphic rocks from the northern Parang Mountains (South Carpathians) were examined to infer the temperature of metamorphism and to obtain new data to study the applicability of the geothermometers relying on the graphite crystallinity to rocks that underwent different shear stress conditions. There were analyzed samples of graphitic carbonaceous matter-bearing rocks that exposed dissimilar degrees of strain for which the temperature of metamorphism was calculated using the graphite geothermometers based on the lattice parameter c(0) determined through X-ray diffractometry and based on the peak area ratio of the first-order Raman spectrum. The temperature was also inferred from the chemical composition of the chlorite and from the Fe-Mg partitioning between chlorite and chloritoid, the mineral chemistry being determined through electron microprobe analyses. The results obtained have shown (i) differences of up to more than 150 degrees C between vicinal strained and less-strained zones when applying the geothermometers based on the graphite crystallinity and (ii) considerable discrepancies between the temperatures calculated based on the graphite crystallinity and those based on the chlorite and chloritoid chemical compositions. These inconsistencies are most likely caused by the fact that the calibration of the graphite geothermometers considers temperature as being exclusively responsible for enhancing the degree of graphite crystallinity and, therefore, these graphite geothermometers should be adjusted accordingly by introducing a correction factor that quantifies the degree of strain of the samples analyzed in order to obtain more accurate results. (C) 2015 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available