Effects of Cutting Edge Microgeometry on Residual Stress in Orthogonal Cutting of Inconel 718 by FEM

Three approaches for modeling residual stresses induced by orthogonal cutting of AISI316L

(2018) R. Grissa et al.   INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES

Influences of Cutting Speed and Material Mechanical Properties on Chip Deformation and Fracture during High-Speed Cutting of Inconel 718

(2018) Bing Wang et al.   Materials

Surface residual stress in high speed cutting of superalloy Inconel718 based on multiscale simulation

(2018) YiHang Fan et al.   Journal of Manufacturing Processes

Influence of customized cutting edge geometries on the workpiece residual stress in hard turning

(2017) Carlos EH Ventura et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

A review on the progress towards improvement in surface integrity of Inconel 718 under high pressure and flood cooling conditions

(2016) Aziz UI Hassan Mohsan et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

The influence of tool micro-geometry on stress distribution in turning operations of AISI 4140 by FE analysis

(2016) Mathias Agmell et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Detecting the key geometrical features and grades of carbide inserts for the turning of nickel-based alloys concerning surface integrity

(2016) A Fernández-Valdivielso et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE

Cutting edge geometries

(2014) B. Denkena et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

Influence of low-plasticity ball burnishing on the high-cycle fatigue strength of medium carbon AISI 1045 steel

(2013) R. Avilés et al.   INTERNATIONAL JOURNAL OF FATIGUE

Prediction of machining induced residual stresses in turning of titanium and nickel based alloys with experiments and finite element simulations

(2012) T. Özel et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

Behavior of austenitic stainless steels at high speed turning using specific force coefficients

(2012) Ana Isabel Fernández-Abia et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Dry machining of Inconel 718, workpiece surface integrity

(2011) A. Devillez et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

A fully coupled thermomechanical two-dimensional simulation model for orthogonal cutting: formulation and simulation

(2011) M Agmell et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Investigation of surface near residual stress states after micro-cutting by finite element simulation

(2010) V. Schulze et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY