Heat transfer of micro-droplet during free fall in drop tube

Phase Selection in Solidification of Undercooled Co–B Alloys

(2017) X.X. Wei et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

Grain nucleation and growth behavior of a Sn-Pb alloy affected by direct current: An in situ investigation

(2017) Fenfen Yang et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

The numerical investigation of flow and heat transfer characteristics of flow past a slit-cylinder

(2017) JianSheng Wang et al.   Science China-Technological Sciences

Influence of heating parameters on properties of the Al-Si coating applied to hot stamping

(2017) WeiKang Liang et al.   Science China-Technological Sciences

Observation of the transition from primary dendrites to coupled growth induced by undercooling within Ni Zr hyperperitectic alloy

(2017) P. Lü et al.   SCRIPTA MATERIALIA

Microstructure evolution and mechanical properties of drop-tube processed, rapidly solidified grey cast iron

(2016) Olamilekan Oloyede et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microgravity Level Measurement of the Beijing Drop Tower Using a Sensitive Accelerometer

(2016) T. Y. Liu et al.   Scientific Reports

Direct formation of peritectic phase but no primary phase appearance within Ni83.25Zr16.75 peritectic alloy during free fall

(2016) P. Lü et al.   Scientific Reports

Heat transfer at nanoscale contacts investigated with scanning thermal microscopy

(2015) Ali Assy et al.   APPLIED PHYSICS LETTERS

Structure and phase-composition of Ti-doped gas atomized Raney-type Ni catalyst precursor alloys

(2015) A.M. Mullis et al.   INTERMETALLICS

Solidification morphology and phase selection in drop-tube processed Ni–Fe–Si intermetallics

(2015) Leigang Cao et al.   INTERMETALLICS

Diffusional constrained crystal nucleation during peritectic phase transitions

(2014) S. Griesser et al.   ACTA MATERIALIA

The origin of anomalous eutectic structures in undercooled Ag–Cu alloy

(2013) C.R. Clopet et al.   ACTA MATERIALIA

Experimental investigations of heat transfer enhancement by plane and curved winglet type vortex generators with punched holes

(2013) Guobing Zhou et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Complex phase separation of ternary Co–Cu–Pb alloy under containerless processing condition

(2013) N. Yan et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Pseudobinary eutectics in Cu–Ag–Ge alloy droplets under containerless condition

(2013) Y. Ruan et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Numerical simulation and experimental investigation of natural convection heat transfer of molten salt around fine wire

(2013) YuanWei Lu et al.   Science China-Technological Sciences

Macrosegregation pattern and microstructure feature of ternary Fe–Sn–Si immiscible alloy solidified under free fall condition

(2011) W.L. Wang et al.   ACTA MATERIALIA

Gas atomization of Al–Ni powders: Solidification modeling and neutron diffraction analysis

(2011) D. Tourret et al.   ACTA MATERIALIA

Seed- and wall-induced heterogeneous nucleation in charged colloidal model systems under microgravity

(2011) Hans Joachim Schöpe et al.   PHYSICAL REVIEW E

Study of thermodiffusion of carbon dioxide in binary mixtures of n-butane & carbon dioxide and n-dodecane & carbon dioxide in porous media

(2010) Alireza Abbasi et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Dynamic thermodiffusion model for binary liquid mixtures

(2009) Morteza Eslamian et al.   PHYSICAL REVIEW E

Simulation of the solidification of gas-atomized Sn-5mass%Pb droplets

(2008) Shu Li et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING