4.7 Article

Numerical investigation of mixture formation and combustion in a hydrogen direct injection plus natural gas port injection (HDI plus NGPI) rotary engine

Journal

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY
Volume 43, Issue 9, Pages 4632-4644

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.ijhydene.2018.01.065

Keywords

Natural gas; Hydrogen; Rotary engine; Mixture formation; Combustion process; 3D dynamic simulation

Funding

  1. National Natural Science Foundation of China [51606089, 51576093]
  2. China Postdoctoral Science Foundation [2016M601735]
  3. Jiangsu Postdoctoral Science Foundation [1701111B]
  4. 333 Project of Jiangsu Province [BRA2016447]
  5. Startup Foundation of Jiangsu University for Advanced Scholars [16JDG045]
  6. Youth Talent Cultivation Plan of Jiangsu University [4111130002]

Ask authors/readers for more resources

Hydrogen direct injection (HDI) in cylinder is considered as an effective method to improve natural gas engine performance. The present study aims to bridge the gap on the HDI in rotary engine, and to investigate the effect of hydrogen injection timing (IT) and hydrogen injection duration (ID) on mixture formation and combustion process of a hydrogen direct injection plus natural gas port injection (HDI + NGPI) rotary engine. Numerical approach was used in this study for obtaining some critical information, which was difficult to obtain through experiment, such as flow field, fuel distribution and some intermediate concentration fields in cylinder. The research results showed that for mixture formation, the distribution law of the hydrogen and the natural gas at the late stages of the compression stroke (100 degrees CA (BTDC)), was as follows: at a fixed ID of 24 degrees CA, with retarded hydrogen IT, the stratification phenomenon of hydrogen became obvious increasingly, and the hydrogen distribution area moved towards the back of the combustion chamber continuously. At a fixed IT of 210 degrees CA (BTDC), with the extension in ID, the accumulation area of hydrogen reduced significantly, and the hydrogen continued to gather in the middle of the combustion chamber. For combustion process, the overall combustion rate for the hydrogen injection strategy which had an IT of 210 degrees CA (BTDC) and ID of 40 degrees CA (case ID5), was the fastest. This was due to the fact that compared with the leading spark plug (LSP), the combustion condition around the trailing spark plug (TSP) has a great influence on the combustion process. For case ID5 at ignition timing, the hydrogen concentration near the TSP is high enough for the rapid formation of flame kernel. Compared with case IT1 which had an IT of 390 degrees CA (BTDC) and an ID of 24 degrees CA, the improved combustion rate of case ID5 had a 11.7% increase in peak pressure, and a 7% decrease in NO emissions. (C) 2018 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available