Modeling and prediction of surface topography with three tool-work vibration components in single-point diamond turning

Theoretical and experimental investigation on modeling of surface topography influenced by the tool-workpiece vibration in the cutting direction and feeding direction in single-point diamond turning

(2016) Fujing Tian et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Subsurface defects structural evolution in nano-cutting of single crystal copper

(2015) Quanlong Wang et al.   APPLIED SURFACE SCIENCE

Fast tool servo diamond turning of optical freeform surfaces for rear-view mirrors

(2015) Fujing Tian et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Investigation of the effects of spindle unbalance induced error motion on machining accuracy in ultra-precision diamond turning

(2015) P. Huang et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Conservation law of surface roughness in single point diamond turning

(2014) W.J. Zong et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Effect of material microstructure and tool geometry on surface generation in single point diamond turning

(2014) M. Tauhiduzzaman et al.   PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY

Investigation on the influence of tool-tip vibration on surface roughness and its representative measurement in ultra-precision diamond turning

(2013) H. Wang et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Dynamic modelling of shear band formation and tool-tip vibration in ultra-precision diamond turning

(2011) H. Wang et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

A theoretical and experimental investigation of the tool-tip vibration and its influence upon surface generation in single-point diamond turning

(2009) H. Wang et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Tool wear control in single-crystal diamond cutting of steel by using the ultra-intermittent cutting method

(2008) YoungChan Song et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE