The effect of ageing process on three-point bending strength and permeability of 3D printed sand molds

Investigating surface roughness of ZE41 magnesium alloy cast by low-pressure sand casting process

(2017) A. Sanitas et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Perspective on 3D printing of separation membranes and comparison to related unconventional fabrication techniques

(2017) Ze-Xian Low et al.   JOURNAL OF MEMBRANE SCIENCE

3D printing for rapid sand casting—A review

(2017) Meet Upadhyay et al.   Journal of Manufacturing Processes

Numerical modeling of the gas evolution in furan binder-silica sand mold castings

(2016) Laurentiu Nastac et al.   INTERNATIONAL JOURNAL OF CAST METALS RESEARCH

Quantifying the Role of Part Design Complexity in Using 3D Sand Printing for Molds and Cores

(2016) Eyad S. Almaghariz et al.   International Journal of Metalcasting

Dynamic measurements of the load on gray cast iron castings and contraction of castings during cooling in furan sand molds

(2016) Naoya Marumoto et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Effect of molding parameters on chemically bonded sand mold properties

(2016) Himanshu Khandelwal et al.   Journal of Manufacturing Processes

Effect of Binder Composition on the Shrinkage of Chemically Bonded Sand Cores

(2014) Himanshu Khandelwal et al.   MATERIALS AND MANUFACTURING PROCESSES

A verification of the thermal stress analysis, including the furan sand mold, used to predict the thermal stress in castings

(2013) Yuichi Motoyama et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Effects of layer thickness and binder saturation level parameters on 3D printing process

(2010) Mohammad Vaezi et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Efficacy of powder-based three-dimensional printing (3DP) technologies for rapid casting of light alloys

(2010) Simranpreet Singh Gill et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Emission of organic compounds from mould and core binders used for casting iron, aluminium and bronze in sand moulds

(2010) Niels Tiedje et al.   JOURNAL OF ENVIRONMENTAL SCIENCE AND HEALTH PART A-TOXIC/HAZARDOUS SUBSTANCES & ENVIRONMENTAL ENGINEERING

Direct metal rapid casting: mechanical optimization and tolerance calculation

(2009) Elena Bassoli et al.   RAPID PROTOTYPING JOURNAL