Investigations on tool temperature with heat conduction and heat convection in high-speed slot milling of Ti6Al4V

Analysis of local cutting edge geometry on temperature distribution and surface integrity when dry drilling of aeronautical alloys

(2017) G. Le Coz et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Experimental investigations on effects of tool flank wear on surface integrity during orthogonal dry cutting of Ti-6Al-4V

(2017) Xiaoliang Liang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Performance prediction of high-pressure coolant assisted turning of Ti-6Al-4V

(2016) Mozammel Mia et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

High-pressure coolant on flank and rake surfaces of tool in turning of Ti-6Al-4V: investigations on surface roughness and tool wear

(2016) Mozammel Mia et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Study on cutting temperature during milling of titanium alloy based on FEM and experiment

(2014) Yong Yang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Analytical modeling and experimental investigation of tool and workpiece temperatures for interrupted cutting 1045 steel by inverse heat conduction method

(2013) Fulin Jiang et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Analysis of transient average tool temperatures in face milling

(2012) Xiaobin Cui et al.   INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER

Temperature Variation in the Cutting Tool in End Milling

(2011) Masahiko Sato et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

High bandwidth temperature measurement in interrupted cutting of difficult to machine materials

(2010) M. Armendia et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

An experimental and numerical study on the face milling of Ti–6Al–4V alloy: Tool performance and surface integrity

(2010) Balkrishna Rao et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

High-speed rotary cutting of difficult-to-cut materials on multitasking lathe

(2008) Hiroyuki Sasahara et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE