PtOx-SnOx-TiO2 catalyst system for methanol photocatalytic reforming: Influence of cocatalysts on the hydrogen production

Effects of modification of PtOx-TiO2 photocatalysts by tin were elucidated by exploring relationships between the structural properties of variously prepared tin-loaded catalysts and their catalytic activity in methanol photocatalytic reforming. Tin free and amorphous tin-oxide decorated TiO2 samples were prepared by sol-gel method from titanium-isopropoxide. In other approach, Sn was loaded onto the sol-gel prepared TiO2 by impregnation followed by calcination. Pt was introduced by impregnation followed by either reduction in H-2 at 400 degrees C or calcination at 300 degrees C. TEM, XRD and Raman spectroscopic measurements proved that TiO2 existed in the form of aggregates of polycrystalline anatase with primary particle size of 15-20 nm in all samples. Photocatalytic hydrogen production was influenced by the combined effect of many parameters. Both the presence of Sn and the way of Pt co-catalyst formation played important role in the activity of these photocatalysts. The Sn introduction by both sol-gel method and impregnation clearly enhanced the photocatalytic activity. H-1 MAS NMR measurements revealed that the Sn introduction reduced the amount of the terminal Ti-OH groups of relatively basic character considered to be unfavorable for the photocatalytic reaction. Presence of SnOx decreased the signal of the undesirable vacancies observed by ESR. Furthermore surface SnOx enhanced the dispersion of Pt. Formation of the Pt co-catalyst by calcination was more favorable than by H-2 treatment. In case of the calcined samples in situ reduction of the Pt nanoparticles at the beginning of the photocatalytic reaction was found to be favorable for the hydrogen production. The relatively modest photocatalytical activity obtained after high temperature H-2 treatment could be related to at least two processes in this system: (i) creation of unfavorable oxygen vacancies and (ii) segregation of SnOx to the surface of the Pt cocatalyst as the result of the air exposure of the alloy type Pt-Sn nanoparticles formed during the H-2 treatment, resulting in a decreased number of active sites for reduction of H+. (C) 2017 Elsevier B.V. All rights reserved.