Microstructure and Mechanical Properties of Ti-6Al-4V Fabricated by Vertical Wire Feeding with Axisymmetric Multi-Laser Source

Selective laser melting-wire arc additive manufacturing hybrid fabrication of Ti-6Al-4V alloy: Microstructure and mechanical properties

(2017) Xuezhi Shi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Selective laser melting of Invar 36: Microstructure and properties

(2016) Chunlei Qiu et al.   ACTA MATERIALIA

Microstructural control in a Ti-based alloy by changing laser processing mode and power during direct laser deposition

(2016) G.A. Ravi et al.   MATERIALS LETTERS

Performance of High Layer Thickness in Selective Laser Melting of Ti6Al4V

(2016) Xuezhi Shi et al.   Materials

The Influence of Process Parameters on the Surface Roughness of a 3D-Printed Co–Cr Dental Alloy Produced via Selective Laser Melting

(2016) Min-Ho Hong et al.   Applied Sciences-Basel

Residual Stress, Defects and Grain Morphology of Ti-6Al-4V Alloy Produced by Ultrasonic Impact Treatment Assisted Selective Laser Melting

(2016) Meixia Zhang et al.   Applied Sciences-Basel

Grain morphology evolution behavior of titanium alloy components during laser melting deposition additive manufacturing

(2015) T. Wang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Microstructure of Interpass Rolled Wire + Arc Additive Manufacturing Ti-6Al-4V Components

(2015) Filomeno Martina et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Effect of the build orientation on the mechanical properties and fracture modes of SLM Ti–6Al–4V

(2014) M. Simonelli et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructural characterization of laser melting deposited Ti–5Al-5Mo–5V–1Cr–1Fe near β titanium alloy

(2013) C.M. Liu et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Mechanical properties of additive manufactured titanium (Ti–6Al–4V) blocks deposited by a solid-state laser and wire

(2011) Erhard Brandl et al.   MATERIALS & DESIGN

Microstructure evolution of sub-critical annealed laser deposited Ti–6Al–4V alloy

(2011) Y. Lu et al.   MATERIALS & DESIGN

Morphology, microstructure, and hardness of titanium (Ti-6Al-4V) blocks deposited by wire-feed additive layer manufacturing (ALM)

(2011) Erhard Brandl et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Additive manufacturing of Ti–6Al–4V components by shaped metal deposition: Microstructure and mechanical properties

(2009) Bernd Baufeld et al.   MATERIALS & DESIGN

Deposition of Ti–6Al–4V using a high power diode laser and wire, Part I: Investigation on the process characteristics

(2008) Sui Him Mok et al.   SURFACE & COATINGS TECHNOLOGY