Strain Rate Effect on Tensile Behavior for a High Specific Strength Steel: From Quasi-Static to Intermediate Strain Rates

Shock and spall behaviors of a high specific strength steel: Effects of impact stress and microstructure

(2017) Wei Wang et al.   JOURNAL OF APPLIED PHYSICS

Deformation mechanisms for superplastic behaviors in a dual-phase high specific strength steel with ultrafine grains

(2017) Wei Wang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ultrastrong steel via minimal lattice misfit and high-density nanoprecipitation

(2017) Suihe Jiang et al.   NATURE

Strain hardening in Fe–16Mn–10Al–0.86C–5Ni high specific strength steel

(2016) M.X. Yang et al.   ACTA MATERIALIA

Mechanical properties of copper/bronze laminates: Role of interfaces

(2016) Xiaolong Ma et al.   ACTA MATERIALIA

Strain rate effects on the mechanical behavior of two Dual Phase steels in tension

(2016) E. Cadoni et al.   European Physical Journal-Special Topics

Strain hardening behaviors and strain rate sensitivity of gradient-grained Fe under compression over a wide range of strain rates

(2016) Fuping Yuan et al.   MECHANICS OF MATERIALS

Mechanical response of dual phase steel at quasi-static and dynamic tensile loadings after initial fatigue loading

(2016) Wojciech Moćko et al.   MECHANICS OF MATERIALS

Back stress strengthening and strain hardening in gradient structure

(2016) Muxin Yang et al.   Materials Research Letters

Novel ultra-high-strength (ferrite + austenite) duplex lightweight steels achieved by fine dislocation substructures (Taylor lattices), grain refinement, and partial recrystallization

(2015) Seok Su Sohn et al.   ACTA MATERIALIA

Influence of the temperature-induced martensitic-austenitic transformation on the strength properties of high-alloy steels under dynamic loading

(2015) A. S. Savinykh et al.   COMBUSTION EXPLOSION AND SHOCK WAVES

Influence of Al content on the strain-hardening behavior of aged low density Fe–Mn–Al–C steels with high Al content

(2015) Z.Q. Wu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Strain rate dependent deformation and failure behavior of laser welded DP780 steel joint under dynamic tensile loading

(2015) Yang Liu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Dynamic shear response and evolution mechanisms of adiabatic shear band in an ultrafine-grained austenite–ferrite duplex steel

(2015) Fuping Yuan et al.   MECHANICS OF MATERIALS

Brittle intermetallic compound makes ultrastrong low-density steel with large ductility

(2015) Sang-Heon Kim et al.   NATURE

Heterogeneous lamella structure unites ultrafine-grain strength with coarse-grain ductility

(2015) Xiaolei Wu et al.   PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA

From High-Entropy Alloys to High-Entropy Steels

(2015) Dierk Raabe et al.   STEEL RESEARCH INTERNATIONAL

Effect of strain rate on ductile fracture initiation in advanced high strength steel sheets: Experiments and modeling

(2014) Christian C. Roth et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Alloy Design, Combinatorial Synthesis, and Microstructure–Property Relations for Low-Density Fe-Mn-Al-C Austenitic Steels

(2014) D. Raabe et al.   JOM

Overview of Lightweight Ferrous Materials: Strategies and Promises

(2014) Radhakanta Rana et al.   JOM

Extraordinary strain hardening by gradient structure

(2014) X. Wu et al.   PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA

Dynamic necking in materials with strain induced martensitic transformation

(2013) R. Zaera et al.   JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS

Experimental study on high strain rate behavior of high strength 600–1000MPa dual phase steels and 1200MPa fully martensitic steels

(2013) Wurong Wang et al.   MATERIALS & DESIGN

Dynamic tensile behaviour of TWIP steel under intermediate strain rate loading

(2013) Shanqing Xu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Mechanical behaviour of dual-phase high-strength steel under high strain rate tensile loading

(2013) Jingui Qin et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure and dynamic tensile behavior of DP600 dual phase steel joint by laser welding

(2013) Danyang Dong et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Compressive behavior and rate-controlling mechanisms of ultrafine grained copper over wide temperature and strain rate ranges

(2013) Tao Suo et al.   MECHANICS OF MATERIALS

Effect of the Strain Rate on the TRIP–TWIP Transition in Austenitic Fe-12 pct Mn-0.6 pct C TWIP Steel

(2013) Sangwon Lee et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Fe–Al–Mn–C lightweight structural alloys: a review on the microstructures and mechanical properties

(2013) Hansoo Kim et al.   SCIENCE AND TECHNOLOGY OF ADVANCED MATERIALS

Multistage strain hardening through dislocation substructure and twinning in a high strength and ductile weight-reduced Fe–Mn–Al–C steel

(2012) I. Gutierrez-Urrutia et al.   ACTA MATERIALIA

Annealing effect on the evolution of adiabatic shear band under dynamic shear loading in ultra-fine-grained iron

(2012) Fuping Yuan et al.   INTERNATIONAL JOURNAL OF IMPACT ENGINEERING

Strain rate sensitivity and deformation kinetics of ECAPed aluminium over a wide range of strain rates

(2012) Tao Suo et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of Al content and precipitation state on the mechanical behavior of austenitic high-Mn low-density steels

(2012) I. Gutierrez-Urrutia et al.   SCRIPTA MATERIALIA

Dynamic tensile behavior of multi phase high yield strength steel

(2011) N.K. Singh et al.   MATERIALS & DESIGN

Tensile deformation of a duplex Fe–20Mn–9Al–0.6C steel having the reduced specific weight

(2011) Si Woo Hwang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Deformation and fracture mechanisms in fine- and ultrafine-grained ferrite/martensite dual-phase steels and the effect of aging

(2010) Marion Calcagnotto et al.   ACTA MATERIALIA

A plastic constitutive equation incorporating strain, strain-rate, and temperature

(2010) Ji Hyun Sung et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Microstructural characterization and evolution mechanism of adiabatic shear band in a near beta-Ti alloy

(2010) Y. Yang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Experimental investigation on martensitic transformation and fracture morphologies of austenitic stainless steel

(2009) Arpan Das et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Tensile Properties of TWIP Steel at High Strain Rate

(2009) Rong-gang XIONG et al.   JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL

Factors influencing the tensile behavior of a Fe–28Mn–9Al–0.8C steel

(2009) Je Doo Yoo et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effects of recrystallization annealing temperature on carbide precipitation, microstructure, and mechanical properties in Fe–18Mn–0.6C–1.5Al TWIP steel

(2009) Singon Kang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High-strain-rate response of ultra-fine-grained copper

(2008) A. Mishra et al.   ACTA MATERIALIA

The dynamic tensile behavior of tough, ultrahigh-strength steels at strain-rates from 0.0002s−1 to 200s−1

(2008) B.L. Boyce et al.   INTERNATIONAL JOURNAL OF IMPACT ENGINEERING

Rate-dependent behavior and constitutive model of DP600 steel at strain rate from 10−4 to 103s−1

(2008) Haidong Yu et al.   MATERIALS & DESIGN

Investigation of the mechanical behaviour of advanced high strength steels under various loading conditions

(2008) M. Geiger et al.   International Journal of Material Forming

Dynamic tensile characteristics of TRIP-type and DP-type steel sheets for an auto-body

(2007) Hoon Huh et al.   INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES

A study of localisation in dual-phase high-strength steels under dynamic loading using digital image correlation and FE analysis

(2007) V. Tarigopula et al.   INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES

Effect of grain and twin boundaries on the hardening mechanisms of twinning-induced plasticity steels

(2007) O. Bouaziz et al.   SCRIPTA MATERIALIA