4.7 Article

Temperature dependence of a magnetically levitated electromagnetic vibration energy harvester

Journal

SENSORS AND ACTUATORS A-PHYSICAL
Volume 256, Issue -, Pages 1-11

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/j.sna.2017.01.011

Keywords

Electromagnetic; Energy harvesting; Magnetic levitation; Magnetic spring; Temperature effect

Funding

  1. UK Engineering and Physical Sciences Research Council (EPSRC) [EP/K031910/1]
  2. Perpetuum Ltd.
  3. University of Southampton
  4. EPSRC [EP/K031910/1] Funding Source: UKRI
  5. Engineering and Physical Sciences Research Council [EP/K031910/1] Funding Source: researchfish

Ask authors/readers for more resources

Electromagnetic vibration energy harvesters including magnetically levitated devices where opposing magnets are used to form the spring have been well documented. The strength of the magnets naturally has a large influence on the dynamic characteristics and output power of such harvesters. However, it can be affected by ambient temperatures which vary from applications to applications. This paper presents investigation into the performance of a magnetically levitated electromagnetic energy harvester under various ambient temperatures. Parameters investigated include magnetic flux density, resonant frequency, damping ratio, open circuit output voltage, velocity of the relative motion and the load resistance. Both simulation and experimental results show that these properties vary with ambient temperatures. The magnetic flux density reduces as the temperature increases which results in lower resonant frequency, lower relative velocity, lower open circuit output voltage and higher damping ratio. Varying resonant frequencies with temperature can lead to harvesters being de-tuned from the target vibration frequency. Decreasing magnetic field strength and increased damping ratios will also reduce output power even if the harvester's resonant frequency still matches the environmental vibration frequency. The power transferred to the electrical load will be reduced due to the variation in the optimal load resistance with temperature. This means the harvester is no longer matched to achieve the maximum harvested power. The specified maximum operating temperature of the magnets was found to lead to partial demagnetisation. When cycling from room to the maximum specified temperature, the magnetic field was initially found to fall but remained constant thereafter. Harvesters were found to operate beyond the specified maximum operating temperature of the magnet, but suffer from a reduced magnetic strength. (C) 2017 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available