The Effect of Aging on the Microstructure of Selective Laser Melted Cu-Ni-Si

Perspectives on Additive Manufacturing

(2016) David L. Bourell   Annual Review of Materials Research

Design for Additive Manufacturing: Trends, opportunities, considerations, and constraints

(2016) Mary Kathryn Thompson et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

Discontinuous precipitates in age-hardening CuNiSi alloys

(2016) Satoshi Semboshi et al.   MATERIALS CHARACTERIZATION

Mechanical Properties and Microstructural Characterization of Cu-4.3 Pct Sn Fabricated by Selective Laser Melting

(2016) Anthony P. Ventura et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Increasing toughness by promoting discontinuous precipitation in Cu–Ni–Si alloys

(2016) Seung Zeon Han et al.   PHILOSOPHICAL MAGAZINE LETTERS

Formation and control of martensite in Ti-6Al-4V alloy produced by selective laser melting

(2016) Jingjing Yang et al.   MATERIALS & DESIGN

Selective laser melting of stainless steel 316L with low porosity and high build rates

(2016) Zhongji Sun et al.   MATERIALS & DESIGN

Mechanical response and deformation mechanisms of ferritic oxide dispersion strengthened steel structures produced by selective laser melting

(2015) Thomas Boegelein et al.   ACTA MATERIALIA

Numerical investigation and an effective modelling on the Selective Laser Melting (SLM) process with aluminium alloy 6061

(2015) Loong-Ee Loh et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Hardened austenite steel with columnar sub-grain structure formed by laser melting

(2015) K. Saeidi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure of selective laser melted nickel–titanium

(2014) Therese Bormann et al.   MATERIALS CHARACTERIZATION

Twinning Induced Plasticity and Work Hardening Behavior of Aged Cu–Ni–Si Alloy

(2014) Akiyoshi Araki et al.   MATERIALS TRANSACTIONS

Orientation and diffraction patterns of δ-Ni2Si precipitates in Cu–Ni–Si alloy

(2013) Yan-lin Jia et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effect of build geometry on the β-grain structure and texture in additive manufacture of Ti6Al4V by selective electron beam melting

(2013) A.A. Antonysamy et al.   MATERIALS CHARACTERIZATION

Microstructures and Properties of 17-4 PH Stainless Steel Fabricated by Selective Laser Melting

(2013) Lawrence E. Murr et al.   Journal of Materials Research and Technology-JMR&T

The crystallographic and morphological evolution of the strengthening precipitates in Cu–Ni–Si alloys

(2012) T. Hu et al.   ACTA MATERIALIA

Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powder

(2012) Lore Thijs et al.   ACTA MATERIALIA

Heat treatment of Ti6Al4V produced by Selective Laser Melting: Microstructure and mechanical properties

(2012) Bey Vrancken et al.   JOURNAL OF ALLOYS AND COMPOUNDS

A study of the microstructural evolution during selective laser melting of Ti–6Al–4V

(2010) Lore Thijs et al.   ACTA MATERIALIA