A novel constitutive model for Ti–6Al–4V alloy based on dislocation pile-up theory

Influence of Ag micro-alloying on the thermal stability and ageing characteristics of a Cu–14Fe in-situ composite

(2016) Keming Liu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Modelling of the hot deformation behaviour of a titanium alloy using constitutive equations and artificial neural network

(2014) Jingwei Zhao et al.   COMPUTATIONAL MATERIALS SCIENCE

Temperature and grain size dependent plastic instability and strain rate sensitivity of ultrafine grained austenitic Fe–14Cr–16Ni alloy

(2014) C. Sun et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of constitutional undercooling on grain refinement in titanium aluminide alloys

(2014) V. E. Bazhenov   MATERIALS SCIENCE AND TECHNOLOGY

Effect of heat treatment on erosive wear behaviour of Ti6Al4V alloy

(2013) S Fidan et al.   MATERIALS SCIENCE AND TECHNOLOGY

Determination of the influence of processing parameters on the mechanical properties of the Ti–6Al–4V alloy using an artificial neural network

(2012) Yu Sun et al.   COMPUTATIONAL MATERIALS SCIENCE

Investigation on high temperature compression behaviour of hydrogenated Ti6Al4V alloy

(2012) X L Cheng et al.   MATERIALS SCIENCE AND TECHNOLOGY

Prediction of flow stress in dynamic strain aging regime of austenitic stainless steel 316 using artificial neural network

(2011) Amit Kumar Gupta et al.   MATERIALS & DESIGN

Grain size effects on deformation twinning in an extruded magnesium alloy tested in compression

(2011) Patrik Dobroň et al.   SCRIPTA MATERIALIA

Influence of grain size and texture on Hall–Petch relationship for a magnesium alloy

(2011) W. Yuan et al.   SCRIPTA MATERIALIA

Deformation of titanium alloy Ti–6Al–4V under dynamic compression

(2010) Qite Zhao et al.   COMPUTATIONAL MATERIALS SCIENCE

Effect of hot working on flow behavior of Ti–6Al–4V alloy in single phase and two phase regions

(2010) A. Momeni et al.   MATERIALS & DESIGN

Finite element simulation of conventional and high speed machining of Ti6Al4V alloy

(2007) Domenico Umbrello   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Artificial neural network modeling of composition–process–property correlations in austenitic stainless steels

(2007) Sumantra Mandal et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING