4.6 Article

UV-A and UV-C light induced hydrophilization of dental implants

Journal

DENTAL MATERIALS
Volume 31, Issue 8, Pages E157-E167

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.dental.2015.04.011

Keywords

Dental implants; Wettability; Roughness; Hydrophilicity; UV; Photocatalysis; Titanium; Anatase; Zirconia; PEEK

Funding

  1. Camlog foundation (Basel, Switzerland) [CF20903]
  2. Ministry of Defense Saudi Arabia
  3. China Scholarship Council

Ask authors/readers for more resources

Objectives. Wettability is increasingly considered to be an important factor determining biological responses to implant materials. In this context, the purpose of this study was to compare the dynamic wettability of dental implants made from different bulk materials and modified by different surface modifications, and to analyze the respective changes of wettability upon irradiating these implants by UV-A or UV-C light. Methods. Four original screw-type implants were investigated: One grit-blasted/acid-etched and one anodically oxidized titanium, one zirconia and one polyetheretherketone implant. Additionally, experimental, screwless, machined titanium cylinders were included in the study. Part of that cylinders and of blasted/etched implants were further modified by a magnetron-sputtered photocatalytic anatase thin film. Scanning electron microscopy was used to investigate the surface micro- and nanostructures. Samples were treated by UV-A (382 nm, 25 mW cm(-2)) and UV-C (260 nm, 15 mW cm(-2)) for entire 40 min, respectively, and their wettability was quantified by dynamic contact angle (CA) analysis from multi-loop Wilhelmy experiments. Results. All implants are characterized by submicron- and nanosized surface features. Unexposed implants were hydrophobic (CA > 90 degrees). Upon UV-A, solely the implants with anatase coating became superhydrophilic (CA < 5 degrees). Upon UV-C, the blasted/etched implants turned superhydrophilic, the anodized titanium and the zirconia implants were considerably (CA = 34 degrees and 27 degrees, respectively) and the PEEK implants slightly (CA = 79 degrees) hydrophilized. Significance. The wettability of implant surfaces can be improved by UV irradiation. The efficiency of UV-A and UV-C irradiation to lower the CA by photocatalysis or photolysis, however, is strongly dependent on the specific material and surface. Thus, attempts to photofunctionalize these surfaces by irradiation is expected to result in a different pattern of bioresponses. (C) 2015 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available