Journal
FUEL
Volume 209, Issue -, Pages 339-349Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.fuel.2017.08.015
Keywords
Compression ratio; DEE port injection; Dual fuel mode; Karanja methyl ester (KME); Upgraded biogas (UBG)
Categories
Ask authors/readers for more resources
In this present investigation, a single cylinder, four stroke, direct injection (DI) diesel engine was modified to operate on dual fuel mode with upgraded biogas (UBG)-Karanja methyl ester (KME). In dual fuel mode, diethyl ether (DEE) was injected as an ignition improver through the air intake manifold of the engine to initiate early combustion of biogas in the combustion chamber. During UBG-KME-DEE operation the compression ratio (CR) of the engine was varied from 16.5 to 18.5 in steps of 1. During investigation, the engine load was varied from 0% to 100% in steps of 25. The DEE injection quantity and the KME injection timing was kept constant at 6% (vol%) and 24.5 degrees CA bTDC (found to be optimum from previous study by the authors) respectively. The results indicated that UBG-KME-DEE operation with CR 18.5 gave optimum result than those of other CRs. For UBG-KME-DEE-CR18.5 the BTE increased and BSFC decreased by about 7% and 2.2% respectively, than that of KME. A reduction in the specific CO, specific HC, and smoke emissions of 42.2%, 39.5%, and 42.8% was observed for UBG-KME-DEE-CR18.5 in comparison to diesel at full load respectively. However, the specific NO emission for UBG-KME-DEE-CR18.5 was 7.6% higher than that of diesel, but it was 1.2% lower than that of KME, at full load.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available