4.7 Article

Combined effect of hysteresis and heterogeneity on the stability of an embankment under transient seepage

Journal

ENGINEERING GEOLOGY
Volume 219, Issue -, Pages 140-150

Publisher

ELSEVIER SCIENCE BV
DOI: 10.1016/j.enggeo.2016.11.011

Keywords

Embankment; Hysteresis; Reliability; Slope stability; Spatial variability; Transient seepage

Funding

  1. China Scholarship Council
  2. Geo-Engineering Section of Delft University of Technology
  3. Marie Curie Career Integration [333177]

Ask authors/readers for more resources

The stability of most earth embankments is strongly influenced by the water content of the soil. The water content directly influences the suction or pore pressure in the soil, as well as the mass of material, thereby affecting the stress state and strength, and leading to changes in the stability. These aspects are coupled by the so-called soil water retention behaviour, which is observed to be a hysteretic phenomenon. Moreover, soils are known to be spatially variable or heterogeneous in nature, which can lead to preferential flow paths and stronger or weaker zones. In this paper the behaviour of a heterogeneous earth embankment subjected to cyclic water level fluctuation, including the impact of hysteresis, is investigated. The soil property values governing the unsaturated hydraulic response of the embankment are considered as spatially random variables, with the mechanical property values considered deterministic in order to isolate the impact of the hydraulic behaviour. The Monte Carlo Method (MCM) is used to conduct probabilistic analyses and an assessment of the relative influence of material properties illustrates that the saturated hydraulic conductivity, k(sat) plays a dominant role in the slope stability. Moreover, in the initially drying condition, the average factor of safety (FOS) and the 95th percentile FOS of the slope considering hysteresis are smaller than those without considering hysteresis, at all times, while the variability of the FOS considering hysteresis is larger than that when not considering hysteresis. In practice, this means that slopes under seepage conditions, which are assessed to have a low FOS, should be assessed including the hysteretic behaviour to ensure stability. (C)2016 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available