4.7 Article

Experimental and numerical study of waste heat recovery characteristics of direct contact thermoelectric generator

Journal

ENERGY CONVERSION AND MANAGEMENT
Volume 140, Issue -, Pages 273-280

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.enconman.2017.03.014

Keywords

Thermoelectric generation (TEG); Direct contact thermoelectric generator (DCTEG); Waste heat recovery; Contact resistance; Power generation; Efficiency

Funding

  1. Development of complex fuel engine technology for high fuel economy project of the Korea Institute of Machinery and Materials under Ministry of Science, ICT and Future Planning, Republic of Korea

Ask authors/readers for more resources

In this study, waste heat recovery performance of a direct contact thermoelectric generator (DCTEG) is experimentally investigated on a diesel engine. In order to conduct an insightful analysis of the DCTEG characteristics, three experimental parameters engine load, rotation speed, and coolant temperature are chosen to vary over ranges during the experiments. Experimental results show that higher temperature differences across thermoelectric modules (TEM), larger engine loads, and rotation speeds lead to an improved energy conversion efficiency of the DCTEG, which lies in the range of approximately 1.0-2.0%, while the output power ranges approximately 12-45 W. The increase in the conversion efficiency for an increased engine load becomes more noticeable with a higher engine rotation speed. A 10 K decrease in the coolant temperature yields an approximately 0.25% increase in the conversion efficiency for the engine operating conditions tested. In addition, 3D numerical simulations were conducted to investigate the heat transfer and pressure characteristics of the DCTEG. Numerically obtained exhaust gas temperatures exiting the DCTEG were in good agreement with experimental results. It is also revealed that incorporation of the temperature fields from the numerical simulation and an empirical correlation for a temperature-power relationship provides a good predictor for output power from the DCTEG, especially at low engine load conditions, which deviates from experimental results as the engine load increases. Heat recovery efficiency of the DCTEG is found to be in the range of approximately 5.7-11.1%, which is yielded by comparing the heat transfer rate from the exhaust gas to a surface of the TEMs to the total exhaust gas energy entering the DCTEG. Numerical results also show that most exhaust gas thermal energy extracted by the DCTEG is used for thermoelectric energy conversion, and only approximately 1/5 of the energy is wasted to the environment regardless of engine load conditions. Owing to a simple internal geometry without any extended surfaces, the DCTEG features a low exhaust gas pressure drop of smaller than 700 Pa even for the maximum exhaust gas flow rate of approximately 322 kg/h. (C) 2017 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available