Multi Directional Forging of 2024 Al Alloy After Different Heat Treatments: Microstructural and Mechanical Behavior

Severe plastic deformation of rheoforged aluminum alloy A356

(2012) A. Dodangeh et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Reprecipitation behavior in Al–Cu binary alloy after severe plastic deformation-induced dissolution of θ′ particles

(2012) Wenjie Huang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Severe plastic deformation of 6061 aluminum alloy tube with pre and post heat treatments

(2012) M.H. Farshidi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Homogenization of ECAPed Al 2024 alloy through age-hardening

(2012) G. Kotan et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Nanostructured aluminium alloys produced by severe plastic deformation: New horizons in development

(2012) I. Sabirov et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of second phase particles on grain refinement during equal-channel angular pressing of an Al–Mg–Mn alloy

(2011) I. Nikulin et al.   ACTA MATERIALIA

Change of anisotropic tensile strength due to amount of severe plastic deformation in aluminum 2024 alloy

(2011) Young Wha Ma et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

The dissolution behavior of θ′ phase in Al–Cu binary alloy during equal channel angular pressing and multi-axial compression

(2010) Zhiyi Liu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Evaluating high-temperature mechanical behavior of cast Mg–4Zn–xSb magnesium alloys by shear punch testing

(2010) R. Alizadeh et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

On strain-induced dissolution of θ′ and θ particles in Al–Cu binary alloy during equal channel angular pressing

(2010) Zhiyi Liu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Predicting grain refinement by cold severe plastic deformation in alloys using volume averaged dislocation generation

(2009) Marco J. Starink et al.   ACTA MATERIALIA

Influence of equal-channel angular pressing on precipitation in an Al–Zn–Mg–Cu alloy

(2009) G. Sha et al.   ACTA MATERIALIA

The formation of nanograin structures and accelerated room-temperature theta precipitation in a severely deformed Al–4wt.% Cu alloy

(2009) Y. Huang et al.   ACTA MATERIALIA

Grain refinement in aluminum alloy 2219 during ECAP at 250°C

(2007) I. Mazurina et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING