Journal
SOLAR ENERGY MATERIALS AND SOLAR CELLS
Volume 155, Issue -, Pages 356-361Publisher
ELSEVIER SCIENCE BV
DOI: 10.1016/j.solmat.2016.06.016
Keywords
Buffer layer; Zinc oxysulfide; Atomic layer deposition; Chalcopyrite; Thin film; Solar cells
Funding
- European Commission within FP7 research project Roll-to-roll manufacturing of high efficiency and low cost flexible CIGS solar modules [283974 R2R-CIGS]
Ask authors/readers for more resources
Zinc oxysulfide has been grown by spatial atomic layer deposition (S-ALD) and successfully applied as buffer layer in Cu(In, Ga)Se-2 (CIGS) solar cells. S-ALD combines high deposition rates (up to nm/s) with the advantages of conventional ALD, i.e. excellent control of film composition and superior uniformity over large-area and even non-flat substrates. Diethylzinc, water and hydrogen sulfite (H2S) have been used as zinc, oxygen and sulfur precursor, respectively. The S/(S+O) ratio in the film is accurately controlled by exposing the substrate simultaneously to both H2O and H2S precursors, which are pre-mixed and co-injected in the same deposition zone. The optoelectronic and morphological properties of Zn(O,S) are characterized as a function of the S/(S + O) ratio. Zn(O,S) buffer layers with different values of S/(S + O) ratio are applied in CIGS solar cells. An optimum value of S/(S+O) ratio of about 0.4 is found for which both the short circuit current density (J(sc) = 34.2 mA/cm(2)) and cell efficiency (eta = 15.9%) increase, as compared to reference cells with CdS buffer layer (J(sc) = 32.1 mA/cm(2), eta = 15.5%). (C) 2016 Elsevier B.V. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available