Determination of residual stress within complex-shaped coarse-grained cobalt–chromium biomedical castings

The influence of alloy composition on residual stresses in heat treated aluminium alloys

(2015) J.S. Robinson et al.   MATERIALS CHARACTERIZATION

Determination and mitigation of the uncertainty of neutron diffraction measurements of residual strain in large-grained polycrystalline material

(2015) Tom M. Holden et al.   JOURNAL OF APPLIED CRYSTALLOGRAPHY

Influence of Drilling Parameters on the Accuracy of Hole-drilling Residual Stress Measurements

(2014) M. Steinzig et al.   EXPERIMENTAL MECHANICS

Improvement of the Contour Method for Measurement of Near-Surface Residual Stresses from Laser Peening

(2013) M. B. Toparli et al.   EXPERIMENTAL MECHANICS

The influence of cooling conditions on grain size, secondary phase precipitates and mechanical properties of biomedical alloy specimens produced by investment casting

(2013) R. Kaiser et al.   Journal of the Mechanical Behavior of Biomedical Materials

Stress induced martensite transformation in Co–28Cr–6Mo alloy during room temperature deformation

(2013) S. Cai et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effects of Section Size, Surface Cooling Conditions, and Crucible Material on Microstructure and As-Cast Properties of Investment Cast Co-Cr Biomedical Alloy

(2013) Ruth Kaiser et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

New insights into hard phases of CoCrMo metal-on-metal hip replacements

(2012) Y. Liao et al.   Journal of the Mechanical Behavior of Biomedical Materials

Validation of Bragg edge experiments by Monte Carlo simulations for quantitative texture analysis

(2011) M. Boin et al.   JOURNAL OF APPLIED CRYSTALLOGRAPHY

Methods of measuring residual stresses in components

(2011) N.S. Rossini et al.   MATERIALS & DESIGN

Strain-induced phase transformation in a cobalt-based superalloy during different loading modes

(2011) Michael L. Benson et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Precipitates in As-Cast and Heat-Treated ASTM F75 Co-Cr-Mo-C Alloys Containing Si and/or Mn

(2011) Alfirano et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Energy selective neutron radiography in material research

(2010) Lidija Josic et al.   APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING

EXPERIMENTAL DETERMINATION OF RESIDUAL STRESSES WITH THE RING-CORE METHOD AND AN ON-LINE MEASURING SYSTEM

(2010) S. Keil   EXPERIMENTAL TECHNIQUES

Comparison of Four Hole-Producing Techniques for the Center-Hole Residual-Stress Measurement Method

(2010) M.T. FLAMAN et al.   EXPERIMENTAL TECHNIQUES

Microstructural characterization of as-cast biocompatible Co–Cr–Mo alloys

(2010) J.V. Giacchi et al.   MATERIALS CHARACTERIZATION

Residual stress measurement by deep hole drilling and trepanning – analysis with distributed dislocations

(2008) R Paynter et al.   JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN