Parameter effects and process modelling of Polyamide 12 3D-printed parts strength and toughness

Sustainable Additive Manufacturing: Mechanical Response of Polyamide 12 over Multiple Recycling Processes

(2021) Nectarios Vidakis et al.   Materials

Tri-objective constrained optimization of pulsating DC sourced magnetic abrasive finishing process parameters using artificial neural network and genetic algorithm

(2021) Shadab Ahmad et al.   MATERIALS AND MANUFACTURING PROCESSES

An investigation of surface quality characteristics of 3D printed PLA plates cut by CO2 laser using experimental design

(2021) J.D. Kechagias et al.   MATERIALS AND MANUFACTURING PROCESSES

An investigation of PLA/W parts quality fabricated by FFF

(2021) Dimitrios Chaidas et al.   MATERIALS AND MANUFACTURING PROCESSES

Surface quality of printed porous materials for permeability rig calibration

(2021) M. Bodaghi et al.   MATERIALS AND MANUFACTURING PROCESSES

Process–Structure–Properties in Polymer Additive Manufacturing via Material Extrusion: A Review

(2019) G. D. Goh et al.   CRITICAL REVIEWS IN SOLID STATE AND MATERIALS SCIENCES

Fused deposition modeling with polyamide 1012

(2019) Xia Gao et al.   RAPID PROTOTYPING JOURNAL

High-Performance Nylon-6 Sustainable Filaments for Additive Manufacturing

(2019) Farina et al.   Materials

Mechanical and cytotoxicity properties of hybrid ceramics filled polyamide 12 filament feedstock for craniofacial bone reconstruction via fused deposition modelling

(2018) Abdul Manaf Abdullah et al.   DENTAL MATERIALS

Effect of the printing bed temperature on the adhesion of parts produced by fused filament fabrication

(2017) Martin Spoerk et al.   PLASTICS RUBBER AND COMPOSITES

Influence of Layer Thickness and Raster Angle on the Mechanical Properties of 3D-Printed PEEK and a Comparative Mechanical Study between PEEK and ABS

(2015) Wenzheng Wu et al.   Materials

Investigation of layer thickness effect on the performance of low-cost and commercial fused deposition modelling printers

(2014) M. Syamsuzzaman et al.   MATERIALS RESEARCH INNOVATIONS