Bending properties of additively manufactured commercially pure titanium (CPTi) limited contact dynamic compression plate (LC-DCP) constructs: Effect of surface treatment

Formation of equiaxed grains in selective laser melted pure titanium during annealing

(2021) Cheng-Lin Li et al.   Journal of Materials Research and Technology-JMR&T

Improved fatigue strength of additively manufactured Ti6Al4V by surface post processing

(2020) M. Kahlin et al.   INTERNATIONAL JOURNAL OF FATIGUE

Fatigue behavior and modeling for additive manufactured 304L stainless steel: The effect of surface roughness

(2020) Seungjong Lee et al.   INTERNATIONAL JOURNAL OF FATIGUE

Laser polishing for improving fatigue performance of additive manufactured Ti-6Al-4V parts

(2020) Seungjong Lee et al.   OPTICS AND LASER TECHNOLOGY

Evaluation of the mechanical and wear properties of titanium produced by three different additive manufacturing methods for biomedical application

(2019) H. Attar et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Fatigue of additive manufactured Ti-6Al-4V, Part I: The effects of powder feedstock, manufacturing, and post-process conditions on the resulting microstructure and defects

(2019) J.W. Pegues et al.   INTERNATIONAL JOURNAL OF FATIGUE

Fatigue of additive manufactured Ti-6Al-4V, Part II: The relationship between microstructure, material cyclic properties, and component performance

(2019) R. Molaei et al.   INTERNATIONAL JOURNAL OF FATIGUE

Influence of defects, surface roughness and HIP on the fatigue strength of Ti-6Al-4V manufactured by additive manufacturing

(2018) Hiroshige Masuo et al.   INTERNATIONAL JOURNAL OF FATIGUE

Additive manufacturing of fatigue resistant materials: Challenges and opportunities

(2017) Aref Yadollahi et al.   INTERNATIONAL JOURNAL OF FATIGUE

Comparative study of commercially pure titanium produced by laser engineered net shaping, selective laser melting and casting processes

(2017) Hooyar Attar et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Comparison of conventional reconstruction plate versus direct metal laser sintering plate: an in vitro mechanical characteristics study

(2017) Pusheng Xie et al.   Journal of Orthopaedic Surgery and Research

Laser and Electron Beam Additive Manufacturing Methods of Fabricating Titanium Bone Implants

(2017) Bartłomiej Wysocki et al.   Applied Sciences-Basel

Characterization of the hydroxyapatite layer formed by fine hydroxyapatite particle peening and its effect on the fatigue properties of commercially pure titanium under four-point bending

(2016) Shoichi Kikuchi et al.   SURFACE & COATINGS TECHNOLOGY

Improving the surface quality and mechanical properties by shot-peening of 17-4 stainless steel fabricated by additive manufacturing

(2016) Bandar AlMangour et al.   MATERIALS & DESIGN

Powder-based Additive Manufacturing for Development of Tailor-made Implants for Orthopedic Applications

(2015) Takayoshi Nakano et al.   KONA Powder and Particle Journal

Metal Additive Manufacturing: A Review

(2014) William E. Frazier   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Overview of current additive manufacturing technologies and selected applications

(2012) Timothy J. Horn et al.   SCIENCE PROGRESS

Single cycle to failure in torsion of three standard and five locking plate constructs

(2011) J. B. Cabassu et al.   VETERINARY AND COMPARATIVE ORTHOPAEDICS AND TRAUMATOLOGY

Single cycle to failure in bending of three standard and five locking plates and plate constructs

(2011) C. A. Blake et al.   VETERINARY AND COMPARATIVE ORTHOPAEDICS AND TRAUMATOLOGY