Wire arc additive manufacturing of AA5183 with TiC nanoparticles

Evolution of crystallographic orientation, columnar to equiaxed transformation and mechanical properties realized by adding TiCps in wire and arc additive manufacturing 2219 aluminum alloy

(2021) Peng Jin et al.   Additive Manufacturing

Review of Aluminum Alloy Development for Wire Arc Additive Manufacturing

(2021) Geir Langelandsvik et al.   Materials

Wire Arc Additive Manufacturing (WAAM) of Aluminum Alloy AlMg5Mn with Energy-Reduced Gas Metal Arc Welding (GMAW)

(2020) Maximilian Gierth et al.   Materials

Comparative study of eutectic Al-Si alloys manufactured by WAAM and casting

(2020) Geir Langelandsvik et al.   The International Journal of Advanced Manufacturing Technology

Nanoparticle-enabled phase control for arc welding of unweldable aluminum alloy 7075

(2019) Maximilian Sokoluk et al.   Nature Communications

Exploring the use of switchback for mitigating homoepitaxial unidirectional grain growth and porosity in WAAM of aluminium alloys

(2019) Yurii Yehorov et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Microstructure Control and Performance Evolution of Aluminum Alloy 7075 by Nano-Treating

(2019) Min Zuo et al.   Scientific Reports

Workpiece vibration augmented wire arc additive manufacturing of high strength aluminum alloy

(2019) Chen Zhang et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Additive manufacturing using WAAM with AA5183 wire

(2018) A. Horgar et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

The influence of build parameters and wire batch on porosity of wire and arc additive manufactured aluminium alloy 2319

(2018) E.M. Ryan et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

A review of the wire arc additive manufacturing of metals: properties, defects and quality improvement

(2018) Bintao Wu et al.   Journal of Manufacturing Processes

Mechanism behind the Inhibiting Effect of CO2 on the Oxidation of Al–Mg Alloys

(2018) Nicholas Smith et al.   INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH

Correlations between Microstructure Characteristics and Mechanical Properties in 5183 Aluminium Alloy Fabricated by Wire-Arc Additive Manufacturing with Different Arc Modes

(2018) Xuewei Fang et al.   Materials

Fatigue damage evolution and lifetime prediction of welded joints with the consideration of residual stresses and porosity

(2017) Fei Shen et al.   INTERNATIONAL JOURNAL OF FATIGUE

3D printing of high-strength aluminium alloys

(2017) John H. Martin et al.   NATURE

Design for Additive Manufacturing: Trends, opportunities, considerations, and constraints

(2016) Mary Kathryn Thompson et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

The effect of inter-layer cold working and post-deposition heat treatment on porosity in additively manufactured aluminum alloys

(2016) Jianglong Gu et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Molten salt assisted solidification nanoprocessing of Al-TiC nanocomposites

(2016) Weiqing Liu et al.   MATERIALS LETTERS

Wire + Arc Additive Manufacturing

(2016) S. W. Williams et al.   MATERIALS SCIENCE AND TECHNOLOGY

Effect of arc mode in cold metal transfer process on porosity of additively manufactured Al-6.3%Cu alloy

(2014) Baoqiang Cong et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Comparison between current models for the strength of particulate-reinforced metal matrix nanocomposites with emphasis on consideration of Hall–Petch effect

(2011) A. Sanaty-Zadeh   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING