Improvement on the machinability characteristics of AA6061-T6/15 wt.% SiC composites by Response Surface methodology

Investigation and optimization of parameters for hard turning of OHNS steel

(2020) Jafrey Daniel James Dhilip et al.   MATERIALS AND MANUFACTURING PROCESSES

Mechanical and Tribological Characterization of Stir Cast AA6061 T6 – SiC Composite

(2020) Karthik Pandiyan G et al.   Silicon

Dry sliding wear behaviour of Al6061–5%SiC—TiB2 hybrid metal matrix composites synthesized by stir casting process

(2020) J Justin Maria Hillary et al.   Materials Research Express

Mechanical and tribological characteristics of ZrO2 reinforced Al2014 matrix composites produced via stir casting route

(2019) Jafrey Daniel James D et al.   Materials Research Express

Abrasive wear of polypropylene/Cloisite 30B/Elvaloy AC 3427 nanocomposites

(2017) D Jafrey Daniel et al.   JOURNAL OF COMPOSITE MATERIALS

Experimental Investigation and Optimization of Machining Process Parameters in AISI D2 Steel Under Conventional EDM and Cryogenically Cooled EDM Process

(2017) S. VinothKumar et al.   TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS

An investigation of material removal rate and surface roughness of squeeze casted A413 alloy on WEDM by multi response optimization using RSM

(2016) R. Soundararajan et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Machining process parameter and surface integrity in conventional EDM and cryogenic EDM of Al–SiC p MMC

(2015) S. Vinoth Kumar et al.   Journal of Manufacturing Processes

Surface integrity evolution and machining efficiency analysis of W-EDM of nickel-based alloy

(2014) L. Li et al.   APPLIED SURFACE SCIENCE

Multi-response optimization of wire electrical discharge machining process parameters for Al7075/Al2O3/SiC hybrid composite using Taguchi-based grey relational analysis

(2014) Shyam Lal et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Experimental investigation and multi-objective optimization of wire electrical discharge machining (WEDM) of 5083 aluminum alloy

(2014) G. SELVAKUMAR et al.   TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA

A dual response surface-desirability approach to process modeling and optimization of Al2O3 powder-mixed electrical discharge machining (PMEDM) parameters

(2012) S. Assarzadeh et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Optimization of Correlated Responses of EDM Process

(2012) Rina Chakravorty et al.   MATERIALS AND MANUFACTURING PROCESSES

Optimization of process parameters in wire electrical discharge machining of TiB2 nanocomposite ceramic

(2011) H Amini et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Optimization of wire electrical discharge machining of pure tungsten using neural network and response surface methodology

(2011) C-J Tzeng et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Cooling Effect on Electrode and Process Parameters in EDM

(2010) Suleiman Abdulkareem et al.   MATERIALS AND MANUFACTURING PROCESSES