Development of a floating liner test rig and lubrication model for the study of the piston compression ring friction force under fully flooded and starved lubrication

Investigation on generation of laser assisted dimples on piston ring surface and influence of dimple parameters on friction

(2018) V. Ezhilmaran et al.   SURFACE & COATINGS TECHNOLOGY

Tribology of new thin compression ring of fired engine under controlled conditions-A combined experimental and numerical study

(2018) Anastasios Zavos et al.   TRIBOLOGY INTERNATIONAL

Investigation of different piston ring curvatures on lubricant transport along cylinder liner in large two-stroke marine diesel engines

(2017) H Overgaard et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY

Transient experimental and modelling studies of laser-textured micro-grooved surfaces with a focus on piston-ring cylinder liner contacts

(2017) Francisco J. Profito et al.   TRIBOLOGY INTERNATIONAL

Looking into a laser textured piston ring-liner contact

(2017) Sorin-Cristian Vlădescu et al.   TRIBOLOGY INTERNATIONAL

Influence on friction from piston ring design, cylinder liner roughness and lubricant properties

(2017) Markus Söderfjäll et al.   TRIBOLOGY INTERNATIONAL

Effects of honed cylinder liner surface texture on tribological properties of piston ring-liner assembly in short time tests

(2017) Wieslaw Grabon et al.   TRIBOLOGY INTERNATIONAL

Component test for simulation of piston ring – Cylinder liner friction at realistic speeds

(2016) Markus Söderfjäll et al.   TRIBOLOGY INTERNATIONAL

Assessment of friction from compression ring conjunction of a high-performance internal combustion engine: A combined numerical and experimental study

(2015) M Gore et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE

Global energy consumption due to friction in trucks and buses

(2014) Kenneth Holmberg et al.   TRIBOLOGY INTERNATIONAL

Direct measurement of piston friction of internal-combustion engines using the floating-liner principle

(2013) Michael Gore et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING

Practical challenges in determining piston ring friction

(2012) Kai Liao et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY

The influence of piston ring geometry and topography on friction

(2012) N Morris et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY

Tri-Axial Force Measurements on the Cylinder of a Motored SI Engine Operated on Lubricants of Differing Viscosity

(2010) Bryan O’Rourke et al.   JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME