Towards strength-ductility synergy in a CrCoNi solid solution alloy via nanotwins

Achieving ultrahigh strength in CoCrNi-based medium-entropy alloys with synergistic strengthening effect

(2020) Xingshuo Liu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High strain rate compression behaviour of single phase CoCuFeMnNi high entropy alloy

(2020) Reshma Sonkusare et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Microstructure and Mechanical Properties of CoCrFeMnNi High Entropy Alloy with Ultrasonic Nanocrystal Surface Modification Process

(2020) Timothy Alexander Listyawan et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

Dynamic mechanical responses of the Al0·1CoCrFeNi high entropy alloy at cryogenic temperature

(2020) Kun Jiang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Annealing hardening in cryo-rolled high-entropy alloys by belated deformation twinning

(2020) Qian Xiao et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

On the low-cycle fatigue response of CoCrNiFeMn high entropy alloy with ultra-fine grain structure

(2020) S. Picak et al.   ACTA MATERIALIA

Effect of Al content and cold rolling on the microstructure and mechanical properties of Al5Cr12Fe35Mn28Ni20 high-entropy alloy

(2019) Sally Elkatatny et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High-entropy alloys

(2019) Easo P. George et al.   Nature Reviews Materials

Simultaneous enhancement of strength and ductility in a NiCoCrFe high-entropy alloy upon dynamic tension: Micromechanism and constitutive modeling

(2019) T.W. Zhang et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Fine-tuning of mechanical properties in V10Cr15Mn5Fe35Co10Ni25 high-entropy alloy through high-pressure torsion and annealing

(2019) Peyman Asghari-Rad et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High entropy alloys: A focused review of mechanical properties and deformation mechanisms

(2019) E.P. George et al.   ACTA MATERIALIA

Combined strengthening from nanotwins and nanoprecipitates in an iron-based superalloy

(2018) B.B. Zhang et al.   ACTA MATERIALIA

Twinning-induced plasticity (TWIP) steels

(2018) Bruno C. De Cooman et al.   ACTA MATERIALIA

Effects of ultrasonic surface mechanical attrition treatment on microstructures and mechanical properties of high entropy alloys

(2018) M.T. Tsai et al.   INTERMETALLICS

Strain rate effects of dynamic compressive deformation on mechanical properties and microstructure of CoCrFeMnNi high-entropy alloy

(2018) Jeong Min Park et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure and properties of bulk Al 0.5 CoCrFeNi high-entropy alloy by cold rolling and subsequent annealing

(2018) Tong Guo et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ultrastrong Medium-Entropy Single-Phase Alloys Designed via Severe Lattice Distortion

(2018) Seok Su Sohn et al.   ADVANCED MATERIALS

Superb cryogenic strength of equiatomic CrCoNi derived from gradient hierarchical microstructure

(2018) Bin Gan et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

Mechanical properties of high-entropy alloys with emphasis on face-centered cubic alloys

(2018) Zezhou Li et al.   PROGRESS IN MATERIALS SCIENCE

Achieving ultra-high strength and ductility in equiatomic CrCoNi with partially recrystallized microstructures

(2018) C.E. Slone et al.   ACTA MATERIALIA

Strengthening in Al 0.25 CoCrFeNi high-entropy alloys by cold rolling

(2017) Jinxiong Hou et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure evolution and critical stress for twinning in the CrMnFeCoNi high-entropy alloy

(2016) G. Laplanche et al.   ACTA MATERIALIA

Alloy design for intrinsically ductile refractory high-entropy alloys

(2016) Saad Sheikh et al.   JOURNAL OF APPLIED PHYSICS

Elastic and plastic properties of as-cast equimolar TiHfZrTaNb high-entropy alloy

(2016) G. Dirras et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Metastable high-entropy dual-phase alloys overcome the strength–ductility trade-off

(2016) Zhiming Li et al.   NATURE

Exceptional damage-tolerance of a medium-entropy alloy CrCoNi at cryogenic temperatures

(2016) Bernd Gludovatz et al.   Nature Communications

Design and tensile properties of a bcc Ti-rich high-entropy alloy with transformation-induced plasticity

(2016) Lola Lilensten et al.   Materials Research Letters

Microstructure and properties of a refractory high-entropy alloy after cold working

(2015) O.N. Senkov et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Temperature dependence of the mechanical properties of equiatomic solid solution alloys with face-centered cubic crystal structures

(2014) Z. Wu et al.   ACTA MATERIALIA

A refractory Hf25Nb25Ti25Zr25 high-entropy alloy with excellent structural stability and tensile properties

(2014) Y.D. Wu et al.   MATERIALS LETTERS

A fracture-resistant high-entropy alloy for cryogenic applications

(2014) B. Gludovatz et al.   SCIENCE

The influences of temperature and microstructure on the tensile properties of a CoCrFeMnNi high-entropy alloy

(2013) F. Otto et al.   ACTA MATERIALIA

Increase in dislocation density in cold-deformed Pd using H as a temporary alloying addition

(2013) Y.Z. Chen et al.   SCRIPTA MATERIALIA

Effects of stacking fault energy, strain rate and temperature on microstructure and strength of nanostructured Cu–Al alloys subjected to plastic deformation

(2011) Y. Zhang et al.   ACTA MATERIALIA

Quantification of the microstructures of high purity nickel subjected to dynamic plastic deformation

(2011) Z.P. Luo et al.   ACTA MATERIALIA

Strength and ductility of 316L austenitic stainless steel strengthened by nano-scale twin bundles

(2011) F.K. Yan et al.   ACTA MATERIALIA

Nucleation and thickening of shear bands in nano-scale twin/matrix lamellae of a Cu–Al alloy processed by dynamic plastic deformation

(2010) C.S. Hong et al.   ACTA MATERIALIA

Interfacial diffusion in a nanostructured Cu produced by means of dynamic plastic deformation

(2010) H.L. Wang et al.   ACTA MATERIALIA

Dislocation nucleation governed softening and maximum strength in nano-twinned metals

(2010) Xiaoyan Li et al.   NATURE

Grain orientation dependence of deformation twinning in pure Cu subjected to dynamic plastic deformation

(2009) C.S. Hong et al.   SCRIPTA MATERIALIA

Mechanical properties and rolling behaviors of nano-grained copper with embedded nano-twin bundles

(2008) Y. Zhang et al.   ACTA MATERIALIA

Microstructural evolution and nanostructure formation in copper during dynamic plastic deformation at cryogenic temperatures

(2007) Y.S. Li et al.   ACTA MATERIALIA