Balling phenomenon in metallic laser based 3D printing process

Particle-reinforced metal matrix nanocomposites fabricated by selective laser melting: A state of the art review

(2019) W.H. Yu et al.   PROGRESS IN MATERIALS SCIENCE

Selective laser melting of titanium alloy with 50 wt% tantalum: Effect of laser process parameters on part quality

(2018) Swee Leong Sing et al.   INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS

Saturated pool boiling of FC-72 from enhanced surfaces produced by Selective Laser Melting

(2016) J.Y. Ho et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Numerical analysis of heat transfer during multi-layer selective laser melting of AlSi10Mg

(2016) Hongwei Hu et al.   OPTIK

Microstructure and mechanical properties of the near-beta titanium alloy Ti-5553 processed by selective laser melting

(2016) H. Schwab et al.   MATERIALS & DESIGN

Numerical investigation and an effective modelling on the Selective Laser Melting (SLM) process with aluminium alloy 6061

(2015) Loong-Ee Loh et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Experimental and numerical analysis of the selective laser sintering (SLS) of PA12 and PEKK semi-crystalline polymers

(2015) Patrice Peyre et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Balling phenomena in selective laser melted tungsten

(2015) Xin Zhou et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titanium

(2012) Dongdong Gu et al.   ACTA MATERIALIA

Balling behavior of stainless steel and nickel powder during selective laser melting process

(2011) Ruidi Li et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Radiation transfer in metallic powder beds used in laser processing

(2010) A.V. Gusarov et al.   JOURNAL OF QUANTITATIVE SPECTROSCOPY & RADIATIVE TRANSFER

Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methods

(2009) Dongdong Gu et al.   MATERIALS & DESIGN

Three-dimensional transient finite element analysis of the selective laser sintering process

(2008) L. Dong et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY