Study of volumetric energy density limitations on the IN718 mesostructure and microstructure in laser powder bed fusion process

Differences in microstructure and nano-hardness of selective laser melted Inconel 718 single tracks under various melting modes of molten pool

(2020) Hongying Wang et al.   Journal of Materials Research and Technology-JMR&T

Analytical Modeling of In-Process Temperature in Powder Bed Additive Manufacturing Considering Laser Power Absorption, Latent Heat, Scanning Strategy, and Powder Packing

(2019) Jinqiang Ning et al.   Materials

Influence of laser processing parameters on porosity in Inconel 718 during additive manufacturing

(2019) Pankaj Kumar et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Analytical modeling of lack-of-fusion porosity in metal additive manufacturing

(2019) Jinqiang Ning et al.   APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING

Experimental analysis of spatter generation and melt-pool behavior during the powder bed laser beam melting process

(2018) V. Gunenthiram et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Laser powder-bed fusion of Inconel 718 to manufacture turbine blades

(2017) Fabrizia Caiazzo et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

The influence of Laves phases on the high-cycle fatigue behavior of laser additive manufactured Inconel 718

(2017) Shang Sui et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Lasers in additive manufacturing: A review

(2017) Hyub Lee et al.   International Journal of Precision Engineering and Manufacturing-Green Technology

Is the energy density a reliable parameter for materials synthesis by selective laser melting?

(2017) K. G. Prashanth et al.   Materials Research Letters

On the limitations of Volumetric Energy Density as a design parameter for Selective Laser Melting

(2017) Umberto Scipioni Bertoli et al.   MATERIALS & DESIGN

Laser powder-bed fusion additive manufacturing: Physics of complex melt flow and formation mechanisms of pores, spatter, and denudation zones

(2016) Saad A. Khairallah et al.   ACTA MATERIALIA

Influence of hatch spacing on heat and mass transfer, thermodynamics and laser processability during additive manufacturing of Inconel 718 alloy

(2016) Mujian Xia et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Additive manufacturing and sustainability: an exploratory study of the advantages and challenges

(2016) Simon Ford et al.   JOURNAL OF CLEANER PRODUCTION

Comparison of Residual Stresses in Inconel 718 Simple Parts Made by Electron Beam Melting and Direct Laser Metal Sintering

(2015) L. M. Sochalski-Kolbus et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Balling phenomena in direct laser sintering of stainless steel powder: Metallurgical mechanisms and control methods

(2009) Dongdong Gu et al.   MATERIALS & DESIGN