Enhanced strength and ductility in an Al–Cu–Li alloy via long-term ageing

Microstructure, mechanical properties and deformation characteristics of Al-Mg-Si alloys processed by a continuous expansion extrusion approach

(2020) Ruiqing Lu et al.   JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY

Precipitation strengthening of aluminum alloys by room-temperature cyclic plasticity

(2019) Wenwen Sun et al.   SCIENCE

Effect of interrupted ageing treatment on the mechanical properties and intergranular corrosion behavior of Al-Mg-Si alloys

(2019) Xu Xuehong et al.   Journal of Materials Research and Technology-JMR&T

Strengthening mechanisms, deformation behavior, and anisotropic mechanical properties of Al-Li alloys: A review

(2018) Ali Abd El-Aty et al.   Journal of Advanced Research

Precipitation structure and strengthening mechanisms in an Al-Cu-Mg-Ag alloy

(2017) M. Gazizov et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Quantification of the influence of increased pre-stretching on microstructure-strength relationships in the Al–Cu–Li alloy AA2195

(2016) B.I. Rodgers et al.   ACTA MATERIALIA

Influence of interrupted quenching and pre-aging on the bake hardening of Al–Mg–Si Alloy

(2016) Lipeng Ding et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A combinatorial approach for studying the effect of Mg concentration on precipitation in an Al–Cu–Li alloy

(2016) E. Gumbmann et al.   SCRIPTA MATERIALIA

Atomic structure and growth mechanism of T1 precipitate in Al–Cu–Li–Mg–Ag alloy

(2015) Sung Jin Kang et al.   SCRIPTA MATERIALIA

Quantification and modelling of the microstructure/strength relationship by tailoring the morphological parameters of the T1 phase in an Al–Cu–Li alloy

(2014) Thomas Dorin et al.   ACTA MATERIALIA

Quantitative description of the T1formation kinetics in an Al–Cu–Li alloy using differential scanning calorimetry, small-angle X-ray scattering and transmission electron microscopy

(2014) Thomas Dorin et al.   PHILOSOPHICAL MAGAZINE

The influence of Cu/Li ratio on precipitation in Al–Cu–Li–x alloys

(2013) B. Decreus et al.   ACTA MATERIALIA

The influence of precipitation on plastic deformation of Al–Cu–Li alloys

(2013) A. Deschamps et al.   ACTA MATERIALIA

Influence of Natural Ageing and Deformation on Precipitation in an Al-Cu-Li Alloy

(2013) Benjamin Decreus et al.   ADVANCED ENGINEERING MATERIALS

Dynamic properties evaluation of 2519A aluminum alloy processed by interrupted aging

(2013) Lingying Ye et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A systematic study of the effect of interrupted ageing conditions on the strength and toughness development of AA6061

(2009) D.D. Risanti et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

On the strengthening response of aluminum alloys containing shear-resistant plate-shaped precipitates

(2008) J. da Costa Teixeira et al.   ACTA MATERIALIA

Microstructural stability during low temperature exposure of alloys within the Al–Li–Cu–Mg system

(2007) S. Katsikis et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING